User manual ZANUSSI ZI6121F

[. . . ] Take utmost care when handling your appliance so as not to cause any damages to the cooling unit with consequent possible fluid leakages. The appliance must not be located close to radiators or gas cookers. Avoid prolonged exposure of the appliance to direct sunlight. There must be adequate ventilation round the back of the appliance and any damage to the refrigerant circuit must be avoided. [. . . ] For safety reasons, minimum ventilation must be as shown in the instructions. Attention: keep ventilation openings clear of obstruction. Should the lining up of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. · Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. · PR168 If the appliance is transported horizontally, it is possible that the oil contained in the compressor flows in the refrigerant circuit. It is advisable to wait at least two hours before connecting the appliance to allow the oil to flow back in the compressor. CONTENTS Fix cover (D) on guide (B) until it clips into place. . 3 Use - Control Panel - Operation - Temperature regulation - Quick-freezing - Warning light - . . 4 Use - Storage of frozen food - Thawing - Ice-cube production - Hints - Hints for freezing - Hints for storage of frozen food - Maintenance . . 5 Maintenance - Periods of no operation - Periodic cleaning - Defrosting - Customer service and spare . . 6 Installation - Location - Electrical connection - Door reversibility . . 7 Installation - Building-in instructions . . 8 B D PR167/1 USE Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 10 2222 314-22 3 Control Panel 6 5 4 3 2 1 Apply the sealing strip pushing it between the refrigerator and the adjacent cabinet. A A. Normal/Super push button Super control light Warning light Pilot light Thermostat knob BCD D724 E Apply covers (B) on joint cover lugs and into hinge holes. Operation Insert the plug into the wall socket. Turn the thermostat knob (E), clockwise, beyond the «O» (STOP) position. The pilot light (D) will light up, indicating that the appliance is powered. The warning light (C) will light up, indicating that the temperature inside the appliance is too high. To stop operation, simply turn the thermostat knob to position «O». B Warning light (C) The temperature alarm light turns on automatically whenever the temperature within the freezer rises above a certain value which might endanger satisfactory long-term conservation. It is perfectly normal for the temperature alarm light to remain lit up for a short time after the freezer is initially turned on. It will remain lit up until the optimum temperature for the conservation of frozen food is attained. D726 Separate parts A, B, C, D as shown in the figure A B C D Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob towards minimum or reduced (colder) by rotating the knob towards maximum. However, the exact setting should be chosen keeping in mina that the temperature inside the refrigerator depends on: · room temperature; · how often the door is opened; · the quantity of food stored; · location of appliance. A medium setting is generally the most suitable. Freezing fresh food The 4-star compartment is suitable for long term storage of commercially frozen food and for freezing fresh food. To freeze fresh foods allow it to run on the fast freeze setting for at least 24 hours before loading food. Place the food to be frozen in the compartments as shown in figure. PR266 Place guide (A) on the inside part of the furniture door, up and down as shown in the figure and mark the position of external holes. [. . . ] After letting the appliance run for at least half an hour, replace the previously removed food into the compartment. D068 The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the following E. E. C. Directives: Important: Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a maechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. [. . . ]