User manual ZANUSSI ZI720/9 K

[. . . ] KÜHLGEFRIERSCHRANK REFRIGERATEURCONGELATEUR TWEEDEURSKOELKAST FRIDGE-FREEZER ZI 720/9 K BEDIENUNGSANLEITUNG MODE D'EMPLOI GEBRUIKSAANWIJZING INSTRUCTION BOOKLET 2222 042-51 WARNINGS GB It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. s General Safety s This appliance should be serviced by an authorized Service Centre, and only genuine spare parts should be used. [. . . ] According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. Push appliance into the housing until stop strip (A) touches the kitchen unit. D567 A Fig. 3 D023 42 If after having carried out the previously described operation there is still some space left between the appliance and the kitchen unit, fit the trimming provided together with the appliance on the stop strip (A). Fig. 4 A D265 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. Fig. 5 D D723 C Press in the joint covers between the appliance and the kitchen unit. Fig. 6 D724 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 B D726 Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 A 20m m PR33 43 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little platee over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 PR35 If the appliance is to be fitted laterally to the kitchen unit, it will be sufficient to loosen the screws of the little plates (D), move them as shown in Fig. 11 D E D734 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. [. . . ] To do this, turn the glass shelf upside down and release the frames as shown in the illustration. The filter may be washed in normal washing-up liquids. 16 Defrosting Frost is automatically eliminated from the evaporator of the refrigerator compartment every time the motor compressor stops, during normal use. The defrost water drains out through a trough into a special container at the back of the appliance, over the motor compressor, where it evaporates. [. . . ]