User manual ZANUSSI ZI7235

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. s s Installation s s s Service / Repair s There are working parts in this product which heat up. [. . . ] Do not use detergents or abrasive powders, as these will damage the finish. It is essential that the appliance be connected to an efficient earth tap. For this purpose the supply cable plug incorporates a special earth contact. If the sockets of your domestic wiring system are not earthed, have the appliance connected to a separate earth wire by a qualified electrician in accordance with existing safety regulations. 18 I nstructions for totally built-in appliances Dimensions of the recess Height Depth Width 1225 mm 550 mm 560 mm 50 mm The appliance's door has been locked in position for transport by means of pins on both sides. According to the door opening direction, remove relevant pins at the top and at the bottom. For safety reasons, minimum ventilation must be as shown in Fig. Attention: keep ventilation openings clear of obstruction. D567 min. 2 Push appliance into the housing until stop strip (A) touches the kitchen unit. D022 Fig. 3 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance hinges. Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D C D727 19 Press in the joint covers between the appliance and the kitchen unit. Fig. 4 D724 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 6 Position the runners (H) at the top and bottom of the inside of the kitchen unit as shown in Fig. 6 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. A 20m m PR33 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 7 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little platee over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. PR35 Fig. 8 20 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. [. . . ] For better use of space, the front half-shelves can lie over the rear ones. Fig. 12 Use and features of the «CRISP'N FRESH»filter The glass shelf on top of the vegetable drawer is fitted with a special filter called «CRISP'N FRESH» which ensures the correct amount of ventilation, and significantly reduces the rate of food dehydration; vegetables therefore store better and keep longer. D689 Cleaning the filter The filter is held by two small support frames which press into position and are therefore easily removed for clearing. To do this, turn the glass shelf upside down and release the frames as shown in the illustration. The filter may be washed in normal washing-up liquids. [. . . ]