User manual ZANUSSI ZI959T

[. . . ] At the end of operations, it is necessary to check if the door of the furniture closes properly. Installation · · · This appliance is heavy. It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a special cable available from the manufacturer or its service agent. [. . . ] To freeze fresh foods it is not necessary to move the thermostat knob from the normal setting. Push the fast freeze switch at least 3 hours before loading food. In any 24 hours you can freeze up to 4 kg. Place the food to be frozen in the lower of the freezer compartment as this is the coldest part. To guarantee a good operation of the appliance during normal use, the drawers should not be removed. 3. Unscrew the pins (B) and the spacers (C) and refit them on the middle hinge of the opposite side. Refit the upper door, the upper pin and the spacer on the opposite side 5. Unscrew the lower pin and remove the spacer and refit them on the opposite side Frozen food storage When first starting-up or after a period out of use, before putting the products in the compartment let the appliance run for at least two hours on the coldest setting, then turn the thermostat knob to the normal operating position. Do not exceed the storage period indicated by the manufacturer. Finally, do not open the door frequently or leave it open longer than is absolutely necessary. min. 200 cm 2 Recess dimensions Height (1) 1780 mm Depth (2) 550 mm Width (3) 560 mm To ensure adequate ventilation, allow the clearances shown in figure. 50 mm min. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. Movable shelves The walls of the refrigerator have runners so that the shelves can be positioned as desired . For better use of space, the front half-shelves can lie over the rear ones. D338 Bottle rack Place bottles in the rack with the bottleneck to the front. Important: Only store unopened bottles horizontally. The bottle rack can be tilted for storing opened bottles. To do this pull the bottle rack forward until it can be tilted upwards, then slide the front support into the next level up. Positioning This appliance should only be installed at a location where the ambient temperature corresponds to the climate classification indicated on the rating plate, which is located at the left on the inside of the appliance. The following table shows which ambient temperature is correct for each climate classification: SN N ST T +10°C to + 32°C +16°C to + 32°C +18°C to + 38°C +18°C to + 43°C The appliance should be located in a dry atmosphere, out of direct sunlight and away from continuous heat and extreme temperature, e. g. not next to a boiler or radiator, or in a very cold room e. g. warmer or colder, then the appliance may not operate correctly. For building-in and door reversal instructions please refer to the relevant instructions on the following pages. Positioning the door shelves To permit storage of food packages of various sizes, the door shelves can be adjusted in height. To do this proceed as shown in the diagram. Shelf holders Your appliance is equipped with shelf retainers that make it possible to secure the shelves during transportation. To remove them proceed as follows: Raise the shelf from the back, push it in the direction of the arrow until it is freed and remove the retainers. B A The top shelf can be removed for easier cleaning. 14 7 HINTS AND TIPS Food Storage · To obtain the best results from your appliance, neither hot foods nor liquids which may evaporate, should be placed in the larder compartment. [. . . ] This guarantee relates to you and cannot be transferred to another user. Your new home is within the European Community (EC) or European Free Trade Area. The product is installed and used in accordance with our instructions and is only used domestically, i. e. The product is installed taking into account regulations in your new country. [. . . ]