User manual ZANUSSI ZK56-48RAL

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] Do not open the door frequently or leave it open longer than is absolutely necessary. Warning Do not put carbonated liquids, (fizzy drinks etc. ), in the freezer compartment. Water ices, if consumed immediately after removal from the freezer, can cause low temperature skin burns. Do not remove items from the freezer if your hands are damp/wet, as this could cause skin abrasions or frost/freezer burns. Attention! In the event of a power failure - DO NOT OPEN THE DOOR, the food in the freezer will not be affected if the power cut is short and the freezer is full. If the temperature in the freezer rises, and the food begins to thaw, do not re-freeze the food without checking its conditions. The following guidelines should assist you. Ice-cream: once thawed should be discarded. Fruits & Vegetables: if soft should be cooked and used up. Breads & Cakes: can be re-frozen without danger. Shellfish: should be refrigerated and used up quickly. casseroles should be refrigerated and used up. Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance, with a brush or vacuum cleaner, see figure. D411 Unscrew the light cover and then pull it outward by pressing as shown in the figure. Unscrew the bulb and replace it with a new 15 watt bulb (available from your nearest Service Force Centre). Replace the light cover by sliding it into its original position and replacing the screw. Automatic Defrosting Your appliance has been designed to be frost free. This means there is no need to defrost your appliance as this will be carried out automatically. Cleaning the filter The filter is held by two small support frames which press into position and are therefore easily removed for cleaning. To do this, turn the glass shelf upside down and release the frames as shown in figure. The filters and the glass cover can be washed gently in warm soapy water, they should not be put in the dishwasher. Replacement filters can be purchased as a spare part from your local Zanussi Service Centre. CONDENSER DEFROST TRAY COMPRESSOR D273 When the appliance is not in use When the appliance is not in use for long periods, disconnect from the electricity supply, empty all foods and clean the appliance, leaving the doors ajar to prevent unpleasant smells. D711 11 SOMETHING NOT WORKING Before contacting your local Service Force Centre, check the following points: Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Symptom No power to the appliance Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the fuse has not blown. The light does not come on Ensure that the bulb is correctly fitted. Check the door light switch is not jammed. The temperature in the fridge or freezer section is too high Check the temperature in the fridge is turned to the correct setting relative to ambient conditions. Check the ambient temperature is within the appliances operating limits of 10C to 32C. [. . . ] Do not obstruct the space underneath. 100 mm A 10 mm B 10 mm NP002 Rear spacers In the bag with the documentation, there are two spacers which must be fitted as shown in the figure. Slacken the screws and insert the spacer under the screw head, then re-tighten the screws. DO NOT install in places with restricted ventilation. Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers. PR107 D200 16 Electrical connections Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ]