User manual ZANUSSI ZK621LX

[. . . ] plastic film, plastic, aluminium) on or near the appliance. How to avoid damage to the appliance · The glass ceramic can be damaged by objects falling onto it. · The edge of the glass ceramic can be damaged by being knocked by the cookware. · Cookware made of cast iron, cast aluminium or with damaged bottoms can scratch the glass ceramic if pushed across the surface. · Objects that melt and things that boil over can burn onto the glass ceramic and should be removed straightaway. [. . . ] · Built-in appliances may only be used after they have built in to suitable built-in units and work surfaces that meet standards. · In the event of faults with the appliance or damage to the glass ceramic (cracks, scratches or splits), the appliance must be switched off and disconnected from the electrical supply, to prevent the possibility of an electric shock. · Repairs to the appliance must only be carried out by trained registered service engineers. Safety during use · Remove stickers and film from the glass ceramic. · There is the risk of burns from the appliance if used carelessly. 14 Description of the Appliance Cooking surface layout Singlecooking zone 1200W Multi-purpose zone 1500/2400W Double ring cooking zone 750/2200W Residual heat indicator Single cooking zone 1800W Residual heat indicator The residual heat indicator lights up, as soon as the corresponding cooking zone is hot. 1 Danger!Af2 ter being switched off, the cooking zones need some time to cool down. Residual heat can be used for melting and keeping food warm. 15 Operating the hob You operate the appliance with the combination appliance's ring switches. The operation and the function of the ring switches is described in the Operating Instructions for the combination appliance. Switching the outer rings on and off is also described there. 3 Whenbriefly. This zonecharacteristicon, allmay a cooking is switched it hum is a of ceramic glass cooking zones and does not impair either the function or the life of the appliance. Tips on Cooking and Frying Cookware · You can recognise good cookware from the bottoms of the pans. The bottom should be as thick and flat as possible. · Cookware made of enamelled steel or with aluminium or copper bottoms can leave discolorations on the glass ceramic surface which are difficult or impossible to remove. Energy saving 2 2 2 2 Always place cookware on the cooking zone before it is switched on. The minimum distances to other appliances and units are to be observed. A protective floor must be installed under the appliance. The cut surfaces of the worktop are to be protected against moisture using a suitable sealant. The sealant seals the appliance to the work top with no gap. Do not use silicon sealant between the appliance and the work top. Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened. Make electrical mains terminal free of voltage. Ensure anti-shock protection through correct installation by a qualified electrician. · The appliance must be connected to the electrical supply by a qualified electrician. · · · · · 1 WARNING! Risk of injury from electrical current. [. . . ] · Have the clamping joints correctedly installed by a qualified electrician. · Use strain relief clamp on cable. · In the event of single-phase or two-phase connection, the appropriate mains cable of type H05BB-F Tmax 90° (or higher) must be used. · If this appliance's mains cable is damaged, it must be replaced by a special cable (type H05BB-F Tmax 90°; or higher). [. . . ]