User manual ZANUSSI ZK73/34EFS

[. . . ] We recommend that the operating instructions be kept near the unit for immediate reference should problems arise. GB This appliance conforms with EC--Directive 73/23/EEC, 90/683/EEC, 89/336/EEC, 93/68/EEC 145 Content Important Safety Information . . 95 95 95 95 For the user The Built- Ceramic Hob . . 83 83 83 For the installer Technical Data . . Installing into a kitchen worksurface . [. . . ] If the cooking zone control (2) is pressed again, the dot appears, and the cooking zone can again be used. -- The locking system protects the following keys of the locked cooking zone from unintentional operation: Keys 4, 5, 6, 7. The timer key (7) can be operated, however, and can be set (see «The Timer Function as an Egg--timer» chapter), but has no influence on the barred cooking zone. 3 13 155 Boost facility This facility provides an initial heat boost to the cooking zone, before its resets to the lower power level selected. The length of the heat boost is dependent on the power level selected as shown in the table below. Selecting the boost facility 1. Press the cooking zone control (2) of the required cooking zone. Using the increase control (5), select a power level between 1- You have 10 seconds in which -8. After 5 seconds, «A» appears in the power level. The cooking zone will now heat up at power level 9, and, after the defined time (see Table 1), will switch down to the selected power level. After 5 seconds, the boost function switches on. With this setting, the cooking zone will heat up for 2. 5 minutes at power level 9, and will then switch down to power level 6. 2 The automatic heat-up function will not be activated if you: => select a power level using the Minus key (4) => select power level 9 Table 1 Power level 1 2 3 4 5 6 7 8 9 Automatic Heat-up function time in minutes 1 3 4, 8 6, 5 8, 5 2, 5 3, 5 4, 5 ------ 156 Indicating the selected power level In order to have the current power level indicated in the Power Level indicator, briefly press (0. 5 secs) the corresponding Cooking zone control (2). Changing the Power Level during the Boost facility 1. The cooking zone required must be activated. The dot (13) must be lit in the respective cooking zone, display. or if you want to switch the timer off early: 1. The desired cooking zone must be activated. The dot (13) must be lit in the respective cooking zone. Using the decrease control (4), run the time down to «00». The timer function is now switched off, although the cooking zone remains activated until you switch it off manually. 7 13 To switch off quickly: 1. The desired cooking zone must be activated. The dot (13) must be lit in the respective cooking zone. By simultaneously pressing the increase and decrease controls (5/4), the cooking zone is switched off. The timer display remains, but is no longer activated. 159 The Timer Function as an Egg- Timer The Timer function can be used as an «egg timer», as long as the timer is not already being used for a cooking zone. Setting the egg timer If the appliance is switched off: 1. Enter the desired time using the increase--decrease controls (4/5). 1 If one or more cooking zones are already in use: 1. Lock all cooking zones (see the «Locking (barring) individual cooking zones» chapter). [. . . ] The latter must not be freely accessible, even for installations away from the wall. Installation cabinets must be installed and secured so that they cannot tip over. 165 Installation dimensions The opening in the cabinet must correspond to the standard dimensions. The necessary information can be found in the dimensional sketch. · The separation between the lower surface of the hob and the parts of the furniture below it must be at least 20 mm. [. . . ]