User manual ZANUSSI ZK87-34EFS

[. . . ] You MUST read it carefully before installing or using the appliance. Installation q q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. Any electrical and plumbing work required to install this appliance should be carried out by a qualified and competent person. [. . . ] NOTE: the refilling of the salt container and the rinse aid dispenser are no longer necessary. In this case rinse aid indicator light will always remain illuminated when the machine is switched on. Select the lowest setting for water hardness. Before the start of the washing programme put the "3 in 1" detergent in the detergent dispenser. NOTE: If the drying results are not satisfactory we recommend that you: 1. Fill up the rinse aid dispenser with rinse aid. Set the rinse aid dosage to position 2. Concentrated detergent Modern detergents for dishwashers are almost exclusively lowalkaline concentrated detergents with natural enzymes in tablet form. Using 50°C washing programmes in conjunction with these concentrated detergents reduces pollution and is good for your dishes, as these washing programmes are specially matched to the dirt-dissolving properties of the enzymes in concentrated detergents. It is for this reason that using 50°C washing programmes in conjunction with concentrated detergents can achieve the same cleaning results that can otherwise only be achieved using 65°C washing programmes. If you decide to turn back to the use of the standard detergent system we advise that you: q q Fill up the dispensers for salt and rinse aid again. Adjust the water hardness setting to the highest setting perform up to 3 normal washing programmes without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. The illumination of End indicator light indicates that the programme has ended. Switch off the dishwasher by returning the programme selector dial to the Off position. Open the dishwasher's door, leave it ajar and wait a few minutes before removing the dishes; in this way they will be cooler and the drying will be improved. Set the "delay start" of a programme: Once the washing programme has been set, press the "Delay Start" button. The corresponding indicator light illuminates. Press the Start/Cancel button, the countdown of the delay start begins automatically. The indicator lights of the phases turn off. The opening of the door will not modify or interrupt the countdown. Once the delay start has elapsed the washing programme will start automatically, the delay start indicator light turns off and the indicator light of the phase in progress illuminates. 7. Unloading the dishwasher Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. [. . . ] For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto a 3/4" inch gas thread spout. The water pressure must be within the limits given in the "Technical specifications". Your local Water Authority will advise you on the average mains pressure in your area. The water inlet hose must not be kinked, crushed, or entangled when it is being connected. [. . . ]