User manual ZANUSSI ZKF641HW

[. . . ] Electric Ceramic Hob ZKF641H Operating and Installation Instructions User Instructions Important hints on safety Description of the appliance Before first use Operating Instructions Ceramic glass surface Heat Controls & Settings Residual heat indicator Pots and pans Energy Saving tips Maintenance and Cleaning Something Not Working Customer Care Service and Spare Parts Guarantee Conditions Service Force Centres 3 4 4 5 5 5 6 6 6 7 8 8 8 9 10 Installation Instructions Technical Details Unpacking and Disposal Installing in the kitchen worktop Building-In Electrical Connection 12 12 12 13 14 RATING PLATE The rating plate is located on the bottom of the appliance. Once the appliance has been built-in the rating plate is no longer visible. Please write the `F Nr. ' into the box below. This appliance is corresponding to the EG-rules 73/23/EWG, 89/336/EWG and 90/683/EWG. This safety information is provided in the interests of your safety. Please read it carefully before installing or using the hob. [. . . ] Never use aggressive or abrasive agents, such as oven sprays, stain or rust removers, scouring powder, or sponges with an abrasive effect. Special cleaning agents such as Vitroclen and ceramic glass scrapers are available from department stores and electrical specialists. Cleaning after each use · Slight, non-burnt soiling can be wiped off with a damp cloth. · Burnt soiling has to be removed with a scraper. Afterwards wipe off the ceramic glass surface with a damp cloth and Vitroclen. Stain removal · Light metallic stains (aluminium residues) can be removed from the cooking zone with a ceramic hob cleaning agent such as Vitroclen. · Sugar solutions, food stuffs with a high sugar content, plastics, or kitchen foil must be removed immediately with a scraper. If this type of soilage is not removed immediately it can cause irreparable damage to the ceramic glass surface. When the surface has cooled wipe over with a damp cloth and Vitroclen. · Before using any detergent or cleaning agent on the ceramic glass surface, ensure they are recommended for use on ceramic hobs. · Do not apply any cleaning agents to hot cooking zones. Ensure that any residues are wiped off before the cooking zones are used again. Special Problems . . . when a chemical cleansing agent is not Use a glass scraper to aid cleaning. If cleaning with a glass scraper and Vitroclen does not help, the décor has been cleaned with an unsuitable cleaning agent or scoured by rough ban bases. when metallic discolouration appears on the The cleansing agents that were used were for the cooking surface. The discolouration can only be removed with difficulty using Vitroclen. when the surface shows scratches or hollows. These flaws are caused by scratching or melted objects and cannot be removed, however, this does not reduce the performance of the hob. 7 If your hob is not functioning correctly please carry out the following checks before calling out an engineer. Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom · The cooking zones do not function. · · · Possible Solution Check the mains has not failed. The cooking zone may have only been switched on for a short while, and is therefore below 60°C. · This is not a fault, the buzzing will disappear as the zone heats up. [. . . ] From the top lay the cooking area into the cutout, adjust concentrically and firmly press down. Check the sealing in the supporting frame for perfect seating and resting without a gap. Please do not apply additional silicone sealing material, the closure will make it harder to dismantle in case 13 of need for service, and may damage the worktop if removing the hob. 5 holes in the bottom of the build-in case are provided for the screws of the fitting plates. [. . . ]