User manual ZANUSSI ZKH 863LX ZAN/HIC-8

[. . . ] ZKT 863 LX Ceramic glass hob Table de cuisson vitrocramique Glaskeramische kookplaat Installation and Operating Instructions Instructions de montage et mode d'emploi Montage- en gebruiksaanwijzing g f l Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. [. . . ] The settings are reset using the + or - timer setting sensor panels. After the set period of cooking time has elapsed the cooking zone automatically switches itself off, an acoustic signal sounds for two minutes and the timer display flashes 00. 3. To switch off the signal, touch the timer sensor panel . 3 To make the setting more quickly, touch any of the + or - timer setting sensor panels until the desired value is reached. If the - timer setting sensor panel is actuated first, the time setting will begin at 99 minutes, and if the + timer setting sensor panel is actuated first, the time setting will begin at 1 minute. 21 Switching off the safety cut-out function before it has come to an end There are two ways to switch off the safety cut-out function before it has come to an end. Switch off the cooking zone and timer simultaneously 1. Using the cooking setting selector sensor panel, reset the desired cooking zone to zero: the cooking zone and timer will switch themselves off. Switch off the timer the cooking zone remains active 1. Select the desired cooking zone using the timer sensor panel. The corresponding control lamp will then flash more rapidly. 2. Using the - timer setting sensor panel, set the timer to 00: only the timer will switch itself off. the cooking zone will remain in operation. Countdown timer To be able to use the countdown timer the appliance must be switched on, but all the cooking zones must be switched off. 2. Set the desired period of time using the + or - timer setting sensor panels. The countdown timer function will be activated after several minutes and the remaining time will be displayed. To reset the remaining time, touch the timer sensor panel and change the setting using the + or - sensor panels for setting the timer. After the set period of time has elapsed an acoustic signal sounds and the timer display flashes 00. 3. To switch off the signal, touch the timer sensor panel. 22 Blocking/unblocking the control panel At any stage of the cooking process the control panel, with the exception of the "On/Off" sensor panel, can be blocked in order to prevent the settings being changed e. g. 1. Touch the "block" sensor panel for approx. one second. 3 The control light for the "block" sensor panel will illuminate. 2. To unblock the panel, touch the "block" sensor panel again for approx. The control light in the "block" sensor panel will go out. When you switch the appliance off the blocking function is automatically switched off. 23 Uses, Tables and Tips Pans You can recognise good pans by their bases. The base should be as thick and flat as possible. Pay particular attention when buying new pans to the diameter of the base. Manufacturers often give only the diameter of the upper rim. [. . . ] The appliance also works perfectly on older networks with AC220V~. The hob is to be connected to the mains using a device that allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 mm, eg. automatic line protecting cut-out, earth leakage tripsorfuse. A type H05VV-F cable or one with a higher grade must be used as the mains connecting cable. [. . . ]