User manual ZANUSSI ZKH2145

[. . . ] User manual Washerdryer ZKH 2145 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel and functions - - - - - - - - - -6-8 Programme table - - - - - - - - - - - - - - - - -9-10 Programme information - - - - - - - - - - - - - -11 Washing and drying hints - - - - - - - - - - - - -12 Before the first use - - - - - - - - - - - - - - - - -15 Operating Sequence - - - - - - - - - - - - - - - -15 Washing - - - - - - - - - - - - - - - - - - - - - - - - -15 2 Drying - - - - - - - - - - - - - - - - - - - - - - - - - -19 Drying programmes - - - - - - - - - - - - - - - - -20 Care and cleaning - - - - - - - - - - - - - - - - - -21 Something not working - - - - - - - - - - - - - - 24 Technical data- - - - - - - - - - - - - - - - - - - - - 28 Consumption values - - - - - - - - - - - - - - - - 29 Installation instruction - - - - - - - - - - - - - - - 30 Environmental concerns - - - - - - - - - - - - - 33 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. [. . . ] · The door will be locked throughout the delay time. If you need to open the door, you must first set the washer dryer to PAUSE by pressing button 8. After you have closed the door, press the same button again. The Delay Start cannot be selected with «Drain» programme. Display The display shows the following information: After selecting a programme the duration of the selected programme appears in minutes or hours and minutes on the display . (e. g. The delay time value decreases by one unit every hour, 90 minutes and then, when 1 hour remain, every minute. The incorrect option selection is indicated by the message Err displayed for a few seconds and by flashing of the red light button 8. 2. 05) 2. 00 During the programme, the time remaining is updated every minute. In the event of operating problems, some alarm codes can be displayed, (see paragraph "Something not working"). Selected drying time After selecting a drying programme programme the drying time is shown in minutes or hours and minutes. After the programme has started, the time remaining is updated every minute. E20 The End of programme or the stop wit water left in the tub is indicated by a flashing zero «0». 1. 00 0 Start the programme by pressing button 8 To start the selected programme, press this button; the corresponding green pilot light stops flashing. The pilot light 9 illuminates to indicate that the appliance starts operating and the door is locked. 17 The Delayed start appears on the display for about 3 seconds, then the duration of the previously selected programme is displayed. IMPORTANT!If an option which is not compatible with the set wash programme is selected, the message Err is displayed for few seconds and the red light of the button 8 flashes for 3 times. Altering an option or a running programme It is possible to change some option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing button 8. Changing a running programme is possible only by resetting it. Turn the programme selector dial to «O» and then to the new programme position. Start the new programme by pressing button 8 again. The washing water in the tub will not empty out. Interrupting a programme Press button 8 to interrupt a programme which is running, the corresponding light starts to flash. Press the button again to restart the programme. Cancelling a programme Turn the selector dial to «O» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing the button 8. If the light 9 goes off, the door can be opened. If it does not go off, this means that the machine is already heating, that the water level is above the bottom edge of the door. [. . . ] This could be done by tying it to the tap with a piece of string or attaching it to the wall. 35° In a sink drain pipe branch. This branch must be above the trap so that the bend is at least 60 cm above the ground. Directly into a drain pipe at a height of not less than 60 cm and not more than 90 cm. The end of the drain hose must always be ventilated, i. e. [. . . ]