User manual ZANUSSI ZKH7014X

[. . . ] The following symbols are used in the text: Safety instructions Warning: Information concerning your personal safety. Important: Information on how to avoid damaging the appliance. Information and practical tips Environmental information 1. These numbers indicate step by step how to use the appliance. These operating instructions contain information on steps you can take yourself to rectify a possible malfunction. [. . . ] 1. Using the timer sensor panel , select the cooking zone for which the safety cut-out is to be set. By touching the timer sensor panel once the first active cooking zone is selected in a clockwise direction, and the corresponding control lamp will flash rapidly. Hereby the (e. g. ) left rear control lamp corresponds to the left rear cooking zone. The next active cooking zone is selected by touching the timer sensor panel again . 20 2. While the control lamp is flashing rapidly, use the + or - timersetting sensor panels to set the desired period of time for this cooking zone up until the point where it automatically switches itself off (e. g. 15 minutes). The safety cut-out function will be activated after several minutes The control lamp will now flash more slowly and the remaining cooking time will be shown in the display as it elapses. If the safety cut-out function has been set for more than one cooking zone, the time displayed will be that for the cooking zone with the shortest period of cooking time remaining. The control lamps for the other cooking zones for which the safety cut-out function has been set will illuminate. To display the remaining cooking time for any of these cooking zones, it must be selected using the timer sensor panel , and the corresponding control lamp will then flash rapidly. To reset the remaining cooking time the desired cooking zone must be selected using the timer sensor panel . The corresponding control lamp will then flash more rapidly. The settings are reset using the + or - timer setting sensor panels. After the set period of cooking time has elapsed the cooking zone automatically switches itself off, an acoustic signal sounds for two minutes and the timer display flashes 00. This can produce permanent scratching if the pan is slid across the surface. · When cold, pan bases are normally bowed slightly inwards (concave). They should never be bowed outwards (convex). · If you wish to use special types of pan (e. g. a pressure cooker, simmering pan, wok, etc. ), please observe the manufacturer's instructions. 2 Energy saving tips · Always position pots and pans before switching on the cooking zone. · Whenever possible always position the lids firmly on pots and pans to cover completely. · Switch off the cooking zones before the end of the cooking time to use the residual heat such as to keep foods warm or for melting. · The base of the pan should be the same size as the cooking zone. 24 Advice on Cooking with and without Automatic Warm up The automatic warm up function is suitable for: · dishes that start off cold, are heated up at high power and do not need to be continually watched when cooking on the selected heat setting, · dishes that are put in a hot frying pan. The automatic warm up function is not suitable for: · goulash, beef olives and similar braised dishes that need continual turning until browned correctly, have liquid added and are then braised until cooked, · dumplings, pasta dishes with large amounts of liquid, · cooking with pressure cookers, · very large quantities of soup/stew with more than 2 litres of liquid. General notes: · When cooking without the automatic warm up function, we recommend the use of a high heat setting to warm up the food (using the button) and then leave the dish to finish cooking at an appropriate lower heat setting. · Take special note of the results when you first use the appliance! [. . . ] · Avoid installing the appliance next to doors and under windows. Otherwise hot cookware may be knocked off the rings when doors and windows are opened. · The hob must be pressed out from below when removed. 33 Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. [. . . ]