User manual ZANUSSI ZKT621LN 50D

[. . . ] It is imperative that this information is observed. 1. Numbered instructions guide you step by step through operation of the appliance. . . . 3 2 After this symbol you will find supplementary information on operating and practical use of the appliance. Tips and instructions for the economical and environmentally sound use of the appliance are marked with this symbol. The instructions on use contain information on dealing with problems yourself if any faults occur - see the section "What to do if". [. . . ] The decimal point indicates that settings can only be made in this cooking zone. When you touch the cooking zone sensor field again, the decimal point goes out and further settings are not possible. To switch off the sensor fields, press + and simultaneously. 3 After you have actuated the "On/Off" sensor field to switch on your unit, one of the cooking zones must be selected with the cooking zone selection keys within approximately 10 seconds. Otherwise, the unit switches itself off again for safety reasons. Heat Level Selection + and For setting and adjusting the heat level (!Increase the heat level with the sensor field +. Reduce the heat level with the sensor field -. Switching Off the Appliance To completely switch off the unit, activate the "On/ Off" sensor field n. 3 Touch the "On/Off" sensor field for approximately 1 second. If several cooking zones are simultaneously in operation, in order to adjust the heat level it is necessary to select the corresponding cooking zone by touching the appropriate sensor field. A decimal point in the display shows the selected cooking zone. 3 After a single cooking zone or the entire cooking field has been switched off, remaining residual heat is shown in the digital displays of the corresponding cooking zones with h (for "hot"). 10 Cooking without the Automatic Heating-Up Function 1. For heating up/browning, select a high power. As soon as steam forms or the fat is hot, switch back to the required continued cooking stage. Reset to zero in order to end cooking. When cooking with the induction cooking zone you should take into account that ­ the heating-up times are reduced by the direct energy transfer to the pan!­ the cooking process stops immediately after the cooking zone is switched off (no boiling over!) 2 Note: Cooking with the Automatic Heating-Up Function All four cooking zones of the cooking field can be controlled in nine stages and have an automatic heating-up function: ­ !, Lowest cooking stage ­ ), Highest cooking stage ­ a, Heating-up function. P appears in the display and the Power function is now active. After a few seconds, the timer is started automatically and shows the time remaining until switchingoff. In addition, the display "Timer active" for the relevant cooking zone lights up, e. g. the top left indicator lamp corresponds to the rear left cooking zone. At the end of the cooking time set, the cooking zone switches off automatically and an acoustic signal sounds. Touch the TIMER W sensor field to switch off the signal and indicator lamp. 3 1 The Power function is activated for a maximum of 10 minutes. Then the cooking zone switches automatically to cooking stage 9. While the Power function of cooking zone 1 is active, the cooking zone 4 (front right induction cooking zone Ø 145mm) can be operated at maximum heat setting 7. 8, 9 or A) is set for cooking zone 4, the cooking stage display alternately shows the set setting and 7. As soon as the Power function has ended with cooking zone 1 (max. 10 minutes), cooking zone 4 automatically changes to the previously set heat setting. 3 For more rapid adjustment, leave your finger on the sensor field + or - until the required value is reached. If the sensor field - is activated first, the time setting starts at 99 minutes. [. . . ] · To remove the hob, it must be pressed out from below. 18 Electrical Connection Only the supply lead fitted on the recess may be used for connecting the unit. Replacement cables can only be obtained from Zanussi customer service. A fixture must be provided in the electrical installation which allows the appliance to be disconnected from the mains at all poles with a contact opening width of at least 3 millimetres. Suitable isolation devices include, e. g. [. . . ]