User manual ZANUSSI ZKT623LBV

[. . . ] Important: Information on how to avoid damaging the appliance. 1. These numbers indicate step by step how to use the appliance. These operating instructions contain information on steps you can take yourself to rectify a possible malfunction. Refer to the section "What to do if. . . ". 2 Contents Operating Instructions . [. . . ] The appliance will switch itself off automatically after a few seconds. Overriding the child safety lock The child safety lock can be overridden in order to use the appliance (until the appliance is switched off again). When the appliance is switched on again the child safety device is activated once again. When the child safety device has been activated, l will be displayed. 2. Touch any two heat setting sensor fields and simultaneously. An acoustic signal will sound as confirmation. The child safety device has been overridden until the appliance is switched off, and the cooking surface can be used as normal. 13 Switching off the child safety lock 1. When the child safety device has been activated, l will be displayed. 2. An acoustic signal will sound as confirmation. 3. The displays will become dark, and the child safety device is switched off. The appliance will switch itself off automatically after a few seconds. 14 Timer There are two ways to use the timer: as a safety cut-out function. Set a cooking period for a cooking zone, and after this time has elapsed the cooking zone will automatically switch itself off. To reset the remaining time, touch the timer sensor panel and change the setting using the or sensor panels for setting the timer. After the set period of time has elapsed an acoustic signal sounds and the timer display flashes 00. To switch off the signal, touch the timer sensor panel. Blocking/unblocking the control panel At any stage of the cooking process the control panel, with the exception of the "On/Off" sensor panel, can be blocked in order to prevent the settings being changed e. g. Touch the "block" sensor panel for approx. The control light for the "block" sensor panel will illuminate. To unblock the panel, touch the "block" sensor panel again for approx. The control light in the "block" sensor panel will go out. 3 When you switch the appliance off the blocking function is automatically switched off. 17 Uses, Tables and Tips Pans The better the pan, the better the results. You can recognise good pans by their bases. The base should be as thick and flat as possible. Pay particular attention when buying new pans to the diameter of the base. Manufacturers often give only the diameter of the upper rim. [. . . ] For protection against moisture, all cut surfaces are to be sealed with a suitable sealant. On tiled work surfaces, the joints in the area where the hob sits must be completely filled with grout. On natural, artificial stone, or ceramic tops, the snap action springs must be bonded in place with a suitable artificial resin or mixed adhesive. Ensure that the seal is correctly seated against the work surface without any gaps. [. . . ]