User manual ZANUSSI ZKT651DX 27F

[. . . ] Induktions-Glaskeramik-Kochfeld Ceramic glass induction hob Table de cuisson vetrocéramique à induction ZKT 651 DX Montage- und Gebrauchsanweisung Installation and Operating Instructions Instructions de montage et mode d'emploi d g f Dear Customer, Please read these user instructions carefully and keep them to refer to later. Please pass the user instructions on to any future owner of the appliance. 1 3 2 The following symbols are used in the text: Safety instructions Warning!Information that affects your personal safety. Information that prevents damage to the appliance. [. . . ] The time counts down. 38 Displaying the time remaining for a cooking zone Step 1. Control panel field Select cooking zone Display Pilot light of the cooking zone selected flashes faster The time remaining is displayed After a few seconds the pilot light flashes more slowly. Switching off the acoustic signal Step 1. Control panel field Touch Acoustic signal Acoustic signal to acknowledge. Acoustic signal stops. 39 Safety cut-out Cooking surface · If after switching on the cooking surface, a heat setting is not set for a cooking zone within approx. 10 seconds, the cooking surface automatically switches itself off. · If one or more sensor fields are covered by objects (a pan, cloths, etc. ) for longer than approx. 10 seconds, a signal sounds and the cooking surface switches off automatically. · If all cooking zones are switched off, the cooking surface automatically switches itself off after approx. Control panel · When the appliance is switched off, if one or more of the sensor fields on the control panel are covered for more that 10 seconds, an acoustic signal sounds. The acoustic signal switches itself off automatically when the sensor fields are no longer covered. Induction cooking zones · In the event of overheating (e. g. when a pan boils dry) the cooking zone automatically switches itself off. Before being used again, the cooking zone must be set to 0 and allowed to cool down. · If cookware that is not suitable is used, flashes in the display and after 2 minutes the display for the cooking zone switches itself off. · If one of the cooking zones is not switched off after a certain time, or if the heat setting is not modified, the relevant cooking zone switches off automatically. Before being used again, the cooking zone must be set to 0. Heat setting V, 1 - 2 3-4 5 6-9 Switches off after 6 hours 5 hours 4 hours 1. 5 hours Tips on Cooking and Frying 3 Information on acrylamides According to the latest scientific knowledge, intensive browning of food, especially in products containing starch, can constitute a health risk due to acrylamides. Therefore we recommend cooking at the lowest possible temperatures and not browning foods too much. 40 Cookware for induction cooking zones Cookware material Cookware material Steel, enamelled steel Cast iron Stainless steel Aluminium, copper, brass Glass, ceramic, porcelain Suitable yes yes if appropriately labelled by the manufacturer ----- 3 Cookware for induction cooking zones is labelled as suitable by the manufacturer. Suitability test Cookware is suitable for induction cooking, if . . . a little water on an induction cooking zone set to heat setting 9 is heated within a short time. a magnet sticks to the bottom of the cookware. 3 Certain cookware can make noises when being used on induction cooking zones. These noises are not a fault in the appliance and do not affect operation in any way. Bottom of the cookware The bottom of the cookware should be as thick and flat as possible. [. . . ] The sealant seals the appliance to the work top with no gap. Do not use silicon sealant between the appliance and the work top. When building in, protect the underside of the appliance from steam and moisture, e. g. Avoid installing the appliance next to doors and under windows. [. . . ]