User manual ZANUSSI ZKT663 LN ZANUSSI/HI

[. . . ] Ceramic glass hob Table de cuisson vitrocramique Glaskeramische kookplaat ZKT663 Installation and Operating Instructions Instructions de montage et mode d'emploi Montage- en gebruikshandleiding g f l Dear customer, Please read these operating instructions carefully. Pay particular attention to the section "Safety information" on the first few pages. Please retain these operating instructions for later reference. Pass them on to possible new owners of the appliance. The following symbols are used in the text: 1 Safety instructions 3 Information and practical tips 2 Environmental information Warning: Information concerning your personal safety. [. . . ] The displays will become dark, and the child safety device is switched off. The appliance will switch itself off automatically after a few seconds. 14 Timer There are two ways to use the timer: as a safety cut-out function. Set a cooking period for a cooking zone, and after this time has elapsed the cooking zone will automatically switch itself off. This function can be used for more than one cooking zone simultaneously. as a countdown timer without a cut-out function ("egg timer"), whereby an acoustic signal can be heard after the set period of time has elapsed. 3 The countdown timer cannot be used if a cooking zone is switched on. Safety cut-out The cooking zone(s) for which you want to use the safety cut-out function must be switched on. Using the timer sensor panel , select the cooking zone for which the safety cut-out is to be set. By touching the timer sensor panel once the first active cooking zone is selected in a clockwise direction, and the corresponding control lamp will flash rapidly. Hereby the (e. g. ) left rear control lamp corresponds to the left rear cooking zone. The next active cooking zone is selected by touching the timer sensor panel again . While the control lamp is flashing rapidly, use the or timersetting sensor panels to set the desired period of time for this cooking zone up until the point where it automatically switches itself off (e. g. The safety cut-out function will be activated after several minutes The control lamp will now flash more slowly and the remaining cooking time will be shown in the display as it elapses. If the safety cut-out function has been set for more than one cooking zone, the time displayed will be that for the cooking zone with the shortest period of cooking time remaining. The control lamps for the other cooking zones for which the safety cut-out function has been set will illuminate. To display the remaining cooking time for any of these cooking zones, it must be selected using the timer sensor panel , and the corresponding control lamp will then flash rapidly. To reset the remaining cooking time the desired cooking zone must be selected using the timer sensor panel . The corresponding control lamp will then flash more rapidly. The settings are reset using the or timer setting sensor panels. 15 After the set period of cooking time has elapsed the cooking zone automatically switches itself off, an acoustic signal sounds for two minutes and the timer display flashes 00. To switch off the signal, touch the timer sensor panel . 3 To make the settingsettingquickly, touch any of more the or timer sensor panels until the desired value is reached. If the timer setting sensor panel is actuated first, the time setting will begin at 99 minutes, and if the timer setting sensor panel is actuated first, the time setting will begin at 1 minute. Switching off the safety cut-out function before it has come to an end There are two ways to switch off the safety cut-out function before it has come to an end. Switch off the cooking zone and timer simultaneously Using the cooking setting selector sensor panel, reset the desired cooking zone to zero: the cooking zone and timer will switch themselves off. Switch off the timer the cooking zone remains active 1. Select the desired cooking zone using the timer sensor panel. The corresponding control lamp will then flash more rapidly. Using the timer setting sensor panel, set the timer to 00: only the timer will switch itself off. [. . . ] Additional silicon sealant must not be applied; this would make removal more difficult when servicing. The hob must be pressed out from below when removed. 25 Electrical Connection Before connecting, check that the nominal voltage of the appliance, that is the voltage stated on the rating plate, corresponds to the available supply voltage. The rating plate is located on the lower casing of the hob. The appliance also works perfectly on older networks with AC220V~. [. . . ]