User manual ZANUSSI ZL714W

[. . . ] REFRIGERATOR ZL714W INSTRUCTION BOOKLET 818 14 54--05/2 Important Safety Instructions Your new fridge may have other functions compared to your previous one. GB These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using the appliance. If you are unsure about any of the meanings or warnings contact the Customer Care Department. It will come in handy if you later sell the cabinet or give it to somebody else. Prior to Installation · Check the appliance for transport damage. [. . . ] Distribute the food products to allow cold air to circulate around them. Make sure that the door is completely closed and that the rubber door seal is complete and clean. The temperature where the cabinet is placed is above normal room temperature. Vegetables and other products that are easily frozen have been placed on a "too cold" shelf. See the chapter "To start the fridge and thermostat control". There is water on the cooling plate inside This is normal. During automatic defrosting, frost thaws on the the refrigerator. cooling plate. 8 Zanussi 818 14 54-05/2 Water is running inside the refrigerator. Clean the water drain and drain hole inside the refrigerator using e. g. Food products could have been placed near the rear of the appliance, preventing the water from running into the drain. Place the drain hose at the back of the cabinet above the drain bowl. See the chapter "Before use" Set a warmer temperature. Make sure that the door is completely closed and that the rubber door seal is complete and clean. The temperature where the cabinet is placed is above normal room temperature. (Try connecting another electrical device to the power outlet. ) The fuse has blown. The power plug is not properly connected. See "Normal operating Sounds" in chapter Hints and Tips. Make sure the pipes at the back of the cabinet not touch each other. If the cushion spacers (between the cabinet wall and pipes) come loose, put them back in place again. Carefully follow the instructions in the chapter "Installing the cabinet". Water comes out on the floor. The compressor operates continuously. The cabinet does not operate at all. Cooling or interior light does not operate. No indicator lamps light. Noise Service and Spare Parts 0870 5 929929 GB In the event of your appliance requiring service, or if you wish to purchase spare parts please contact your local Zanussi Service Force Centre by telephoning: Your tephone call be automatically routed the Service Force Centre covering your post code area. The address are listed on the following pages. [. . . ] The following table shows which ambient temperature is correct for each climate classification. Climate classification SN N ST T for an ambient temperature of +10°C to +32°C +16°C to +32°C +18°C to +38°C +18°C to +43°C a) b) 50mm Check that the drain hose at the rear of the cabinet discharges into the drip tray. If the cabinet is placed in a corner and the side with the hinges facing the wall, the distance between the wall and the cabinet must be at least 10 mm to allow the door to open enough so that the shelves can be removed. The power plug must be accessible after installation of the cabinet. 14 Zanussi 818 14 54-05/2 Electrical connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. The manufacturer declines any liability should these safety measures not be observed. Electrical Requirements Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. [. . . ]