User manual ZANUSSI ZM30THW

[. . . ] Save these instructions and make sure that they remain with the appliance if it is moved or sold, so that everyone using it through its life will be properly informed on appliance use and safety. · Under no circumstances should you attempt to repair the machine yourself. Repairs carried out by inexperienced persons will cause injury or serious malfunctioning. Contact your local Service Force Centre. [. . . ] Close the lid and press until it indicated by "max" locks. IMPORTANT!Top up the rinse aid when the light on the control panel Never fill the rinse aid dispenser with any other substances (e. g. dishwasher cleaning agent, liquid deter- illuminates. Therefore always clean left-overs · Steel items prone to rusting. from silver immediately, if it is not to be washed · Wooden platters. · Items made from synthetics fibres. Long blades knives stored in an upright position are a potential hazard. Long and/or sharp items of cutlery such as carving knives must be placed horizontally in the removable knife basket, which is positioned at the rear of the upper basket. 14 Load cutlery. For best results we recommend you to use the cutlery grid provided (if the size and dimensions of the cutlery allow it) Place knives and other Load the lower basket. Arrange serving dishes and items of cutlery with sharp large lids around the edge of the basket. points or edges with their handles facing upwards. Risk of injury! The two rows of prongs on the lower basket can be easily lowered to allow you to load pots, pans and bowls. Load upper basket. · The activation/deactivation of the rinse aid dispenser can only be possible with the "Multi-tab" function active. Activation/deactivation of the rinse aid dispenser 1. Press simultaneously buttons B and C, until the lights of buttons A , B, and C start flashing. Press button B, the lights of buttons A and C turn off while the light of button B goes on flashing. The digital display indicates the current setting: = Rinse aid dispenser deactivated. To change the setting, press button B again, the digital display indicates the new setting: = Rinse aid dispenser activated. To memorise the operation, switch off the dishwasher by pressing the On/Off button. If you decide to turn back to the use of standard detergent system we advise that you: 1. Deactivate the "Multi-tab" function. Fill up the salt container and the rinse aid dispenser again. Adjust the water hardness setting to the highest setting and perform 1 normal washing programme without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. [. . . ] Only use, for connection to the water mains, new hose-set; old hose-set must not be reused. If the machine is connected to new pipes or pipes which have not been used for a long time, you should run the water for a few minutes before connecting the inlet hose. Water connection WARNING!The dishwasher must not be connected to open water appliances or instantaneous water heaters. This dishwasher may be fed with either hot 25 Water inlet hose with safety valve Connect the inlet hose to a water tap with an external thread of 3/4". [. . . ]