User manual ZANUSSI ZOU332FTIN

[. . . ] Einbau-Herd mit Gas-Kochmulde Built-under oven with gas hob ZOU 332 FTI Bedienungs- und Einbauanweisungen Instruction booklet CZ English Warnings - Built-under ovens It is most important that the instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. Installation Any installation work must be undertaken by a qualified electrician or competent person. [. . . ] It may be necessary to increase or decrease the temperatures to suit individual preferences and requirements. Cooking times in the tables do not include pre-heating. We recommend, especially when cooking cakes, pizza and bread, to pre-heat the oven for about 10 minutes before cooking. (**)Cooking times in the table do not include pre-heating. We recommend to pre-heat the oven for about 5 minutes before cooking. 37 Cleaning and Maintenance Before any cleaning switch the oven off and let it cool down. Never use steam or steam machines to clean the appliance. Before carrying out maintenance and cleaning operations, make sure that your oven is disconnected from the mains power supply. Cleaning must be carried out after the oven has cooled down. Wash the enamelled parts with lukewarm water and detergent. Do not use abrasive products, such as steel wool pads, acids etc. since these could damage the various surfaces. Rinse stainless steel parts with water after use, and dry them with a soft cloth or chamois leather. In the case of persistent stains, you can use normal non-abrasive detergents or products specific for stainless steel readily available on the market. Another alternative is a drop of hot vinegar. When cleaning the oven door with the glass top cover use just hot water, taking care to avoid using coarse cloths or abrasive products. Iemons, stewed prunes, etc. ) leave difficult-to-remove stains on the enamelled surfaces; this inconvenient may remove enamel gloss, but, it does not impair oven operation. Clean the oven thoroughly after use; in this way it will be possible to remove cooking residuals more easily, thus avoiding these from burning the next time the oven is used. Models in stainless steel or aluminium: We recommend to clean the oven door using only a wet sponge and dry it up after cleaning with a soft cloth. Never use steel wool, acids or abrasive products as they can damage the oven surface. Clean the oven control panel following the same precautions. Oven door cleaning For a better cleansing of the oven door, you are suggested to remove it from the appliance with the following procedure: - open tho door completely; lift the small levers placed on the two hinges and turn the levers towards the inside (Fig. - Slowly close the oven door, until it touches the two levers, - then push it towards the oven and remove it by pulling it towards the outside. After cleaning, assemble the door again by carrying out the procedure described above backwards. [. . . ] This appliance is delivered without an electric supply cable. Therefore, you will have to fit to it to a supply cable with standard plug, suitable for the total electric load shown on the rating plate. The plug is to be inserted into a suitable wall socket. If you require a direct connection to the electric network (mains), it will be necessary to fit between the appliance and the mains an omnipole switch, with a minimum gap between contacts of 3 mm, suitable for the required load and in compliance with rules in force. [. . . ]