User manual ZANUSSI ZP1705

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. If you are unsure about any aspect of the information in this book, please contact our customer care department on 08705 727 727 Installation q q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. [. . . ] NOTE: If the drying results are not satisfactory we recommend that you: 1. Fill up the rinse aid dispenser with rinse aid. Set the rinse aid dosage to position 2. Concentrated detergent Modern detergents for dishwashers are almost exclusively lowalkaline concentrated detergents with natural enzymes in tablet form. Using 50°C washing programmes in conjunction with these concentrated detergents reduces pollution and is good for your dishes, as these washing programmes are specially matched to the dirt-dissolving properties of the enzymes in concentrated detergents. It is for this reason that using 50°C washing programmes in conjunction with concentrated detergents can achieve the same cleaning results that can otherwise only be achieved using 65°C washing programmes. If you decide to turn back to the use of the standard detergent system we advise that you: q q Fill up the dispensers for salt and rinse aid again. Adjust the water hardness setting to the highest setting and perform up to 3 normal washing programmes without loading any dishes. Adjust the water hardness setting according to the hardness of the water in your area. Adjust the rinse aid dosage. q q NOTE: When using 4 in 1 detergents that integrate also antiglass corrosion agent into "3 in 1" formula, please follow the same instruction as given for "3 in 1" detergents above. POURING EASY PACK TION DOUBLE AC BRILLIANT RILLIANT SHINE FOR A N EW LIQUID GEL POWDER RINSE C O N C E N T R AT E D D I S H WA S H E R D E T E R G E N T 11 Washing programmes Programme Degree of soil and type of load Position of the programme selector dial Cycle description (2) Consumption values Programme duration (in minutes) Energy consumption (in kWh) Water consumption (in litres) Intensive 70° Heavy soil. Crockery, cutlery, pots and pans A Hot prewash Main wash up to 70°C 2 warm rinses 1 hot rinse Drying Cold prewash Main wash up to 65°C 2 warm rinses 1 hot rinse Drying Main wash up to 60°C 1 hot rinse 85 - 95 1, 7 - 1, 9 23 - 25 Normal 65° Normal soil. Crockery and cutlery B 108 - 118 1, 7 - 1, 8 24 - 26 Quick Wash 60° Light soil Crockery and cutlery C 25 - 35 0, 7 - 0, 8 8 (1) Economy 50° Normal soil. Crockery and cutlery D Cold prewash Main wash up to 50°C 1 cold rinse 1 hot rinse Drying 150 1, 05 16 (1) Testing programme for EN 50242 (see "Hints for Test Centres"). Press the Start/Cancel button, the countdown of the delay start begins automatically. The indicator lights of the phases turn off. The opening of the door will not modify or interrupt the countdown. Once the delay start has elapsed the washing programme will start automatically, the delay start indicator light turns off and the indicator light of the phase in progress illuminates. 7. Unloading the dishwasher Hot dishes are sensitive to knocks. The dishes should therefore be allowed to cool down before removing from the appliance. Empty the lower basket first and then the upper one; this will avoid water dripping from the upper basket onto the dishes in the lower one. Water may appear on the sides and the door of the dishwasher as the stainless steel will eventually become cooler than the dishes. To cancel a "Delay Start" in progress Press the Start/Cancel button for about 5 seconds, the indicator lights of Start/Cancel and Delay Start buttons turn off while the indicator lights of the phases start flashing. To start the selected washing programme press the Start/Cancel button. When the washing programme has finished, it is recommended that the dishwasher is unplugged and the water tap turned off. NOTE: the washing programme or the countdown of the delay start will begin only after having pressed the Start/Cancel button. Until that moment it is possible to modify the selection made. 13 Maintenance and cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. [. . . ] When the appliance is correctly levelled, the door will not catch on either side of the cabinet. If the door does not close correctly, loosen or tighten the adjustable feet until the machine is perfectly level. Water supply connections We recommend that this dishwasher is connected to your cold water supply. For making the connection itself, the coupling nut fitted to the machine's supply hose is designed to screw onto a 3/4" gas thread spout. The water pressure must be within the limits given in the "Technical specifications". [. . . ]