User manual ZANUSSI ZP3175

[. . . ] Ensure that the door of the dishwasher is always closed when it is not being loaded or unloaded. In this way you will avoid anybody injuring themselves on the open door. If you take any dishes out of the dishwasher before the end of the dishwashing cycle, it is extremely important to rinse them thoroughly under running water to remove any remaining detergent. The water safety system protects against water damages. [. . . ] The required programme starts immediately. -6- Adjusting the water softener To prevent limescaling on the dishes and to the interior of the dishwasher, the dishes must be washed with soft water. This dishwasher is equipped with a water softener, where tapwater which is harder than 4 °d (german degree) is softened. Adjust the water softener according to the table below for the water hardness level for your area. Contact your local Water Authority to find the exact water hardness level for your area. The water softener has 5 settings: Water hardness level °d 1) > 24 18 - 24 12 - 18 4 - 12 below 4 mmol/l 2) 4, 2 3, 2 - 4, 2 2, 1 - 3, 2 0, 7 - 2, 1 below 0, 7 Setting on the water softener 5 4 3* 2 1 no salt is needed 1) german degree of measurement for the water hardness 2) millimol, internationel unit for water hardness *) factory setting In the following settings the dishwasher must be switched off and all programmes completed. See chapter "Using the appliance" for information on how to complete the programme. Press the combination buttons simultaneously and hold them pressed in. When the first three programme indicator lamps starts to flash, release the buttons. The lamp for the water softener starts to flash. The water hardness level is raised by 1 step every time you press the water softener button. After hardness level 5 comes hardness level 1. Press in the On/Off button. Cancelling the programme 1. Press and hold in the combination buttons, the machine goes to starting position and all programme indicator lamps are lit. The programme is now cancelled and a new programme can be selected. If you switch the dishwasher off with the On/Off button, the selected programme is not finished, it is only disrupted. When you start the dishwasher again, the programme will continue. Be careful if you open the door immediately after the programme is finished, since hot steam may escape. This dishwasher is equipped with the new flush system called "IMPULSE WASHING". This washing system varies both the revolutions of the pump and the water pressure for more intensive cleaning of the dishes during a programme. That is why different sections of the programme cycle do not sound the same. Cleaning the dishwasher Clean the outside surfaces of the appliance using a mild (non-abrasive) household cleaning product. Finish by removing remaining traces of the product with a damp cloth. Do not use cleaning products which contain alcohol (spirits), thinners and similar substances. - 10 - In the event of a fault Before calling out an engineer, please check through the details below because some faults can be rectified easily without the need to call out an engineer. If an engineer is called to resolve a problem listed below or to repair a fault caused by incorrect installation or mis-use a charge will be made, even if the appliance is under guarantee. Fault The programme will not start. Check · · · · · · · · · · · · Is the door closed properly? [. . . ] Remove the water inlet and discharge hoses. Make sure that there is coarse-grained salt in the salt container for the water softener. The appliance is only to be used and stored indoors at normal room temperature. The manufacture is not responsible for any frost damage. - 14 - Installation Water inlet The dishwasher is equipped with safety features which are to prevent the water from going back to the fresh water system. [. . . ]