User manual ZANUSSI ZPC426D

[. . . ] Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can be acquainted with the functioning of the appliance and the relevant warnings. These warnings are provided in the interest of safety. You must read them carefully before installing or using the appliance. This appliance is designed to be operated by adults. [. . . ] Turn the hinge upside down; position it and screw it on the opposite side. Remove the screws which blank off the holes, then position the middle hinge on the opposite side, slightly lifting the doors, making sure that the doors are properly aligned. 1 Location The appliance should be installed well away from sources of heat such as radiators, boilers, direct sunlight etc. Best performance is obtained with ambient temperature between +18°C and +43°C (class T); +18°C and +38°C (class ST); +16°C and +32°C (class N); +10°C and +32°C (class SN). The class of your appliance is shown on its rating plate. For building into kitchen units follow the special "Building-in" instructions given. Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. A D148 Fig. 2 1 2 3 4 D150 Cleaning the interior Before using the appliance for the first time, wash the interior and all internal accessories with lukewarm water and some neutral soap so as to remove the typical smell of a brand-new product, then dry thoroughly. Do not use detergents or abrasive powders, as these will damage the finish. 3 5 Building-in The housing dimensions should be as follows: Height Minimum depth Minimum width 1446 mm 550 mm 560 mm 6 D151 Cooling air comes in through the ventilation grid at the bottom of the appliance. To ensure air circulation, leave a ventilation gap at the back of the appliance, having the following dimensions: depth: 50 mm, width: 540 mm (Fig. A similar gap must also be left in the top of the kitchen furniture. Remove the two spacer bushes (A) then fit the appliance into the recess in the tall kitchen unit. Using the four screws supplied with the appliance, secure the four corners of the appliance cabinet hinge to the tall kitchen unit. 5 50 Fitting door panels To fit the door panel, proceed as follows: Loosen the screws fixing the side frame (Fig. [. . . ] 9 D037 16 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Interior light The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover. Periodic cleaning Clean the inside with warm water and bicarbonate of soda. [. . . ]