User manual ZANUSSI ZPC428DM

[. . . ] Read this instruction manual carefully and follow the recommendations it provides to benefit from years of excellent service. The appliance which you have just purchased has been very accurately controlled throughout the entire manufacturing process. Nevertheless, should any problem arise during usage, whether it be during the warranty period, or when such period has expired, please contact your nearest Zanussi Service Centre immediately. The address and telephone number of this Centre can be easily found in the enclosed List or by looking in the telephone directory, under Zanussi. [. . . ] 1 1 Power connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed, connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with EEC directive number 87/308 of 2/6/87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 2 D561 Fig. 2a 3 Cleaning the appliance's interior Before using the appliance for the first time, wash all internal parts with lukewarm water and neutral soap so as to remove the typical «new» smell and then dry thoroughly. Do not use detergents or abrasive powders as these will damage the finish. D562 6 4 5 12 Left hand door opening Remove the screws and the upper pivots. 2) and fix it to the other side, after having removed the little caps which cover the holes and which must be refitted on the opposite side. Replace the upper door and fix the screw and the upper left pivot into place. Straighten the safety washer (4) of the lower right hinge (Fig. For safety reasons, bend the safety washer located under the left hinge (Fig. Remove the door's top right hinge (3-Fig. 3 Building-in The housing dimensions should be as follows: Height Minimum depth Minimum width 1580 mm 550 mm 560 mm Cooling air comes in through the ventilation grid at the bottom of the appliance. To ensure air circulation, leave a ventilation gap at the back of the appliance, having the following dimensions: depth: 50 mm, width: 540 mm (Fig. A similar gap must also be left in the top of the kitchen furniture. Fit the appliance into the housing and secure it with the the top frame screws (Fig. 5 50 54 0 D563 P Fitting door panels To fit the door panel, proceed as follows: Loosen the screws fixing the side frame (Fig. 4); loosen all the other screws fixing the door frame; insert the panel from the side on which the frame has been removed and push it through; refit the frame on the door again and tighten all the screws. [. . . ] Clean the interior periodically with lukewarm water and some sodium bicarbonate; the cabinet exterior with a silicone wax spray; the condenser and the motor compressor with a brush or a vacuum cleaner. During periods when the appliance is not in use, take the following precautions: unplug the appliance from the power supply; remove all foodstuffs from the appliance; clean the interior and all accessories; leave the doors ajar to allow air to circulate inside the cabinet so as to prevent the formation of unpleasant odours. Interior light bulb (Fig. 11) The light inside the refrigerator compartment is easy to get at. If the light does not come on when the door is opened, make sure it is properly fitted; if the malfunction continues, replace the light bulb using a new light bulb with the same rating. [. . . ]