User manual ZANUSSI ZR 304 CTH

[. . . ] DO NOT USE SHARP INSTRUMENTS to scrape off frost or ice. Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. [. . . ] 3) s Drill the unit using a Ø 2. 5 mm drill (10 mm max. penetration); Fix the square fitting (1) to the appliance and apply the rubber seal; Fit the refrigerator into the space recessing it by 48 mm in relation to the unit base (Fig. Fix the refrigerator with the screws (2) to the upper and lower part of the unit . Fix the square fitting (1) to the unit column. Insert the hinge cover (4). D740 13mm 2 1 s s s 4 3 s s s Fig. 4 13 Instructions to assemble the Fig. 5 A refrigerator door to the kitchen unit door Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. PR33 20m m Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. 8mm Fig. 6 Remove the little plates and make the holes with a diam. Replace the little platee over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. PR34 Fig. 7 Reversibility of the freezer door When changing the hinges of the refrigerator door from right to left, it is also advisable to change the opening side of the freezer door . Please take the following steps: - Remove the door lower hinge. - Remove the freezer door and take of the upper hinge. - Unscrew the catch and fix it on the opposite side . - Mount the freezer door on the left side and fix PR35 Fig. 8 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. [. . . ] Important A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. D037 Fig. 12 17 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: s Warning This appliance contains hydrocarbons in its cooling unit maintenance and recharging must therefore only be carried out by authorized technicians. unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. s Internal clearing Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. If the door is open and the light does not come on, check that the bulb is properly screwed in; if it stili does not work, replace the bulb with one of the same power. The maximum rating is shown on the light cover. External clearing Wash the outer body with lukewarm water and soap. [. . . ]