User manual ZANUSSI ZR220/100H

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. s s Installation s s s There are working parts in this product which heat up. [. . . ] Fasten the appliance with 4 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. D D723 C Fig. 5 D724 Press in the joint covers between the appliance and the kitchen unit. Fig. 6 B D726 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 A 20m m Position the runners (A) at the top and bottom of the inside of the kitchen unit as shown in Fig. and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. PR33 15 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 8 8mm PR34 Remove the little plates and make the holes with a diam. Replace the little platee over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. PR35 Fig. 10 If the appliance is to be fitted laterally to the kitchen unit, it will be sufficient to loosen the screws of the little plates (G), move them as shown in Fig. Fit the cover (H). D E The doors can be opened using the sliding systempreviously illustrated, or one of the two doors can be opened by fitting the small handle supplied as an accessory. D734 Fig. 11 Electrical connection D029 Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. 16 GB USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. The appliance will start to operate. GB Temperature regulation The temperature is automatically regulated and can be increased to achieve a higher temperature (warmer) by rotating the thermostat knob toward lower settings or reduced (colder) rotating the knob towards higher settings. However, the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored; location of appliance. [. . . ] Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. D037 Fig. 16 D068 19 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: Internal clearing Never use metal objects for clearing your appliance as it may get damaged. When performing a complete defrosting, wash the internal surfaces of the freezer with lukewarm water and bicarbonate; rinse and then accurately dry. s s unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. External clearing Wash the outer body with lukewarm water and soap. Periodically use a clearing polish to keep the outer body shining. [. . . ]