User manual ZANUSSI ZR220/100N

[. . . ] Children should not be allowed to tamper with the controls or play with the product. " Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. " This product should be serviced by an authorized Service Centre, and only genuine spare parts should be used. " It is dangerous to alter the specifications or modify this product in any way. [. . . ] Remove centre hinge (A) and refit it on the opposite side. Refit the door and (P) on the left-hand side and remove (P1) from the right-hand side. 13 Housing dimensions Height Depth Width 1780 mm 550 mm 560 mm To ensure adequate ventilation, allow the clearances shown in figure 2. 50-min. 5 Press in the joint covers between the appliance and the kitchen unit. Fig. 6 Apply covers (B) on joint cover lugs and into hinge holes. 3 Push appliance into the housing until stop strip (A) touches the kitchen unit. A B D096 D023 Fig. 4 Open the door and push the appliance against the side of the kitchen unit opposite to that of appliance D hinges. Fasten the appliance with 4 C D092 screws provided in the kit included with the appliance. Snap vent grille (C) and hinge cover (D) into position. Fig. 7 Position the runners (E) at E the top and bottom of the inside of the kitchen unit as shown in Fig. 7 20m m and mark the position of the external holes. D285 After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. 14 8mm PR34 Fig. 8 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. G H D291 Fig. 10 If the appliance is fixed to the side of the kitchen unit, simply slacken the screws in fixing brackets (G), move the brackets as shown in the figure and retighten the screws. 11 The doors can be opened using the sliding system previously illustrated, or one of the two doors can be opened by fitting the small handle supplied as an accessory. Fig. 9 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). PR35 For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. D029 15 USE Operation Insert the plug into the wall socket. Open the refrigerator door and turn the thermostat knob, clockwise, beyond the «O» (STOP) position. [. . . ] Important: A temperature rise of the frozen food packs, during defrosting, may shorten their safe storage life. 18 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. Interior light The light inside the refrigerator compartment is easy to get at through the opening in the light holder. If the light does not come on when the door is open, check that it is screwed into place properly. If it still does not light up, change the bulb. The rating is shown on the light bulb cover. Periodic cleaning Clean the inside with warm water and bicarbonate of soda. [. . . ]