User manual ZANUSSI ZR290/3TN

[. . . ] Frost may be removed by using the scraper provided. Under no circumstances should solid ice be forced off the liner. Solid ice should be allowed to thaw when defrosting the appliance. Do not place carbonated or fizzy drinks in the freezer as it creates pressure on the container, which may cause it to explode, resulting in damage to the appliance. Installation There are working parts in this product which heat up. [. . . ] Snap vent grille (C) and hinge cover (D) into position. D Fig. 5 D288 C 18 Press in the joint covers between the appliance and the kitchen unit. Fig. 6 D030 Apply covers (B) on joint cover lugs and into hinge holes. Fig. 7 B D013 Position the runners (E) at the top and bottom of the inside of the kitchen unit as shown in Fig. 8 and mark the position of the external holes. After preparing the holes, screw the runners to the kitchen unit door using 3. 5x16 mm screws. Fig. 8 E 20m m D285 Open both the appliance door and that of the kitchen unit to approx. Place the little plates over the runners. Hold the doors of the appliance and the unit together and mark the holes. Fig. 9 8mm PR34 19 Remove the little plates and make the holes with a diam. Replace the little plates over the runners and screw in the screws provided (3. 5x16 mm). For the alignment of the kitchen unit door, if necessary, use the clearance size of the slotted holes. At the end of the procedure, check that the doors of the appliance and the kitchen unit open properly. Fig. 10 PR35 In case of side fixing of the appliance, it will be sufficient to loosen the screws fixing the brackets (G) and to position them as shown in Fig. 11 G H G D708 The doors can be opened using the sliding system previously illustrated, or one of the two doors can be opened by fitting the small handle supplied as an accessory. Fig. 12 D029 Electrical connection Before plugging in, ensure that the voltage and frequency shown on the serial number plate correspond to your domestic power supply. Voltage can vary by ±6% of the rated voltage. For operation with different voltages, a suitably sized auto-transformer must be used. TECHNICAL SPECIFICATION The technical data is indicated in the rating plate on the left side inside the appliance. 20 GB OPERATION Starting-up - Temperature Regulation Turn the thermostat knob clockwise to the required setting (beyond position «O»); the recommended setting is between 2 and 4. Temperature is regulated automatically and can be increased by turning the knob to lower numbers, or decreased by turning it to higher numbers. However the exact setting should be chosen keeping in mind that the temperature inside the refrigerator depends on: room temperature; how often the door is opened; the quantity of food stored in the refrigerator; location of appliance. To stop the appliance, simply turn the thermostat knob to position «O». GB Refrigeration of foods and drinks To achieve the best results with the refrigerator compartment, you should follow one or two very simple rules: Do not put warm foods or evaporating liquids in the refrigerator. [. . . ] 16 D037 PR138 24 MAINTENANCE Unplug the appliance before carrying out any maintenance operation. GB Interior light The light bulb inside the refrigerator compartment can be reached as follows: unscrew the light cover securing screws; unhook the moving part by pressing it as shown in the figure. If the door is open and the light does not come on, check that the bulb is properly screwed in; if it still does not work, replace the bulb with one of the same power. The maximum rating is shown on the light cover. 18 Periodical cleaning Clean the interior periodically with lukewarm water and some bicarbonate of soda. Idle periods During periods when the appliance is not in use, take the following precautions: unplug the appliance from the power supply; remove all foodstuffs from the appliance; defrost the appliance and clean the interior and all accessories; leave the doors ajar to facilitate the circulation of air in the interior of the cabinet so as to prevent unpleasant odours from accumulating in the appliance. D411 CUSTOMER SERVICE If the appliance is not working properly, before calling the service center, please check the following: The light does not turn on when the door is opened Make sure there is electricity supply; if there is, replace the bulb. [. . . ]