User manual ZANUSSI ZRD33SX8

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 2 IMPOR TANT S AFET Y INS TR UCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. [. . . ] Never try to free an ice tray that is frozen to the freezer compartment by using pointed or sharp edged objects. Frozen Food Storage When first starting the freezer or if the freezer has been out of use for some time, we advise you to run your appliance for at least 2 hours before storing frozen food. Do not exceed the storage period indicated by the manufacturer. Do not open the door frequently or leave it open longer than is necessary. Important Do not put carbonated liquids in the freezer. Ice lollies, if consumed immediately after removal from the freezer can cause a low temperature skin burn. In the event of a power cut the food in the freezer will not be affected if the power cut is short and the freezer is full. Should the food begin to thaw it must be consumed quickly and must not be re-frozen. (See Hints and Tips) 8 Hints & T ips Normal Operating Sounds You may hear faint gurgling or bubbling sounds when the refrigerant is pumped through the coils or tubing. When the compressor is on, the refrigerant is being pumped round and you will hear a whirring sound or pulsating noise from the compressor. A thermostat controls the compressor and you will hear a faint 'click' when the thermostat cuts in and out. Energy Saving Advice Do not install the appliance close to sources of heat, such as a boiler or radiator. Locate the appliance in a cool well ventilated room and make sure that the air openings of the appliance are not obstructed. Press the rear hook (1) and at the same time slide the cover in the direction indicated by arrow (2). (Bulb type: 230-240 V, 15 W, E 14 thread) After changing the bulb replace the cover, snap it in place and apply voltage to the appliance. 11 Something N ot Working If the appliance is not working correctly, please carry out the following checks before contacting your local Service Force Centre. Problem Possible Cause No power to the appliance No power at the socket. Thermostat control knob is set at , , 0". The temperature in the The appliance is located in an unsuitable position. fridge or freezer is too high The thermostat control knob is set too low. Solution Check there is power at the socket. Check there is not a power cut by checking the household lights. Check the ambient temperature is within the appliances operating limits of 10 °C to 32 °C. Check that the thermostat control knob is turned to the correct setting relative to ambient conditions. Close the door. The compressor runs continuously The temperature in the fridge or freezer is too low Excessive frost and ice has The door has been left open. built up Something is obstructing the door. [. . . ] After released the screws the adaptation of the doors can be adjusted with the horizontal control of central door holder. Put the appliance to its place, set it level and connect to the electricity supply. In case you do not want to perform the procedures above, call the nearest brand-mark service. Technicians will accomplish the refitting expertly for charge. [. . . ]