User manual ZANUSSI ZRG316CW

[. . . ] Instead it shall be handed over to the applicable collection point for the recycling of electrical and electronic equipment. By ensuring this product is disposed of correctly, you will help prevent potential negative consequences for the environment and human health, which could otherwise be caused by inappropriate waste handling of this product. For more detailed information about recycling of this product, please contact your local city office, your household waste disposal service or the shop where you purchased the product. 2 IMPOR TANT S AFET Y INS TR UCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. [. . . ] When ice coating is so thick that it cannot be removed with the plastic scraper, the cooling gill have to be defrosted. Frequency of defrosting depends on usage 10 (generally 2-3 times a year). Take the frozen foods out of the appliance, and put them into a basket lined with paper or cloth. Store them in a possibly cool place or replace them into another refrigerator. Pull out the mains plug from the mains socket, so both parts of the appliance are out of operation. Open the doors of both parts of the appliance and clean the refrigerator according to 'Regular cleaning'. Maintain and clean the freezer as following: Sweep off the melting water with a cloth or sponge in direction of sides of the cooling plates. The melting water swept down gathers in the outlet channel practically formed in the bottom of the appliance and can be removed according to figure. Put an adequately high bowl or dish under the outlet. The bowl in figure is not a piece of accessories to the appliance!Wipe the surfaces after defrosting and leading the water out. Products placed in can prevent water from flowing into the collector. Water flows onto the The melting water outlet flows not into floor. the evaporative tray above the compressor. There are too much frost Products are not wrapped properly. Doors are not shut properly or do not close tightly. The thermostatic control can be set wrongly. The compressor The thermostatic control is set wrongly. Doors are not shut properly or do not close tightly. Products in big quantity to be frozen were put in. The appliance is in too warm place. Solution Set the thermostat knob to higher position. Place the products to the appropriate place. [. . . ] 2. 18 Fit the refrigerator door to the upper door hinge pin (d) then slightly tilting both doors fit the pin of the double door hinge (m) into the left drill of the refrigerator door. Opening both doors fix the double door hinge onto the left side using the screws (2 pieces) (c). Do not forget to replace the plastic spacer (b) under the hinge. Be careful that the door edges are parallel with the edge of the mantle. [. . . ]