User manual ZANUSSI ZRI51L

[. . . ] This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation q q Check your dishwasher for any transport damage. If your dishwasher is damaged, you should contact your supplier. For safety reasons it is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] Replace the cap tightly turning it clockwise until it stops with a click. Ensure that the lid is closed after every refill. Clean up any rinse aid spilt during filling with an absorbent cloth to avoid excess foaming during the next wash. Only use branded rinse aid for dishwashers. Never fill the rinse aid dispenser with any other substances (e. g. dishwasher cleaning agent, liquid detergent). This would damage the appliance. The salt container will require topping up periodically. You are reminded of this by the salt indicator light on the control panel which comes on when the salt has finished. The salt indicator light on the control panel can remain illuminated for 2-6 hours after the salt has been replenished, assuming the dishwasher remains switched on. If you are using salts that take longer to dissolve then this can take longer. The function of the machine is not affected. Do not worry if water overflows from the unit when filling with salt, this is quite normal. Adjusting the dose According to the finish and drying results obtained, adjust the dose of rinse aid by means of the 6 position selector (position 1 minimum dosage, position 6 maximum dosage). Serving dishes and large lids should be arranged around the edge of the basket, ensuring that the spray arms can turn freely. 9 The cutlery basket is in two parts which can be separated to give greater loading flexibility. To separate the two parts, slide them horizontally in opposite directions and pull them apart. To reassemble, reverse the procedure. Adjusting the height of the upper basket If washing very large plates you can load them in the lower basket after moving the upper basket to the higher position. Maximum height of the dishes in upper basket lower basket With upper basket raised With upper basket lowered 20 cm 24 cm 31 cm 27 cm To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outwards and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. The upper basket The upper basket is designed for plates (dessert plates, saucers, dinner plates of up to 24 cm in diameter), salad bowls, cups and glasses. Arrange items on and underneath the cup racks so that water can reach all surfaces. Glasses with long stems can be placed upside down in the cup racks. For taller items, the cup racks can be folded upwards. Light items (plastic bowls etc. ) must be loaded in the upper basket and arranged so they do not move. When the basket is in the higher position you will not be able to use the cup rack(s). After loading your machine always close the door, as an open door can be a hazard. In case that plates are loaded in the upper basket: load them starting from the rear positions of the basket; tilting them slightly forwards and avoiding the front positions near the door. Before closing the door, ensure that the spray arms can rotate freely. 10 Use of detergent Only use detergents specifically designed for use in dishwashers. Using no more than the correct amount of detergent contributes to reducing pollution. [. . . ] The programme will continue from the point at which it was interrupted. If the fault code reappears contact the Service Force Centre. For other combinations of fault codes not described in the above chart, please contact your Service Force Centre. . . . there are problems when operating the dishwasher Malfunction Possible cause The dishwasher door has not been properly closed. The programme does not start The fuse has blown in the household fuse box. [. . . ]