User manual ZANUSSI ZSF6280

[. . . ] Dishwasher ZSF 6280 User information g Dear Customer, Please read these user instructions carefully and keep them to refer to later. Please pass the user instructions on to any future owner of the appliance. The following symbols are used in the text: 1 Safety instructions 3 Useful tips and hints 2 Environmental information Warning!Notes that concern your personal safety. Notes that show how to avoid damage to the appliance. 2 Contents Operating Instructions . [. . . ] The selected dishwashing cycle will begin. In the text line of the display you will see the name of the current programme stage. Next to this you will see the estimated remaining duration in minutes. Using the Options button you can briefly display the name of the dishwashing cycle in the display. Interrupting the dishwashing programme by opening the dishwasher door opened. There is a risk of scalding. 1 Hot steam may escape when the door is 1. Open the door carefully. The dishwashing cycle will stop, in the display: PLEASE CLOSE DOOR 2. Close the door. The cycle will continue. Cancelling the dishwashing cycle 1. Press the Cancel button. In the display: CHOOSE PROGRAMME 3. If you want to start a new dishwashing cycle, check whether there is any detergent in the dispenser. 3 A dishwashing cycle can only be started from the Programmes menu. 3 During the dishwashing cycle, the remaining If the dishwashing cycle does not start: 3 Turning off the dishwasher will only interrupt a Setting the Delay Timer selected dishwashing cycle, not cancel it. The cycle will recommence after turning the dishwasher back on again. time shown in the display may be adjusted according to the size of the load, degree of soiling, etc. 3 With the delay timer you can delay theand 19 start of a dishwashing cycle for between 1 hours. First set the Delay Start and then the desired dishwashing cycle. 1. Press the Delay Start button repeatedly until the desired period by which you want to delay the start is displayed in the display. lights up in the symbol line of the display. First the pre-set time delay counts down. In the display you will see START IN and the time remaining until the start of the dishwashing cycle. After the time delay the dishwashing cycle begins automatically, the symbol goes out. If after pressing the Ok/Start button, the programme does not start and a message appears in the display (REFILL RINSE AID, REFILL SALT or PLEASE CLOSE DOOR): · Follow the instructions in the message. After the problem has been remedied, the cycle starts automatically. 3 With the messages REFILL RINSE AID or RE3 While a dishwashing cycle settings. you canis running, not change the options or Interrupting or Cancelling a dishwashing cycle Interrupt a dishwashing cycle that is in progress if it is absolutely necessary. FILL SALT you can however start the cycle, by pressing the Ok/Start button again. Cancelling a delay start: You can cancel a delay start that is counting down at any time. The dishwasher cycle that is set begins. 25 Switching Off the dishwasher Switch off the dishwasher if the messages PROGRAMME END and PLEASE SWITCH OFF are being displayed alternately. With some dishwashing cycles, the drying fan continues to run even after the end of the cycle. If the acoustic signal has been enabled, a continuous tone will sound for 15 seconds at the end of the dishwashing cycle. [. . . ] Should a fault occur when the appliance is switched on, a buzzing tone can also be heard. 40 Electrical Connection Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. The manufacturer declines any responsibility should these safety measures not be observed. Before switching on make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. To isolate the dishwasher from the mains, remove the mains plug. [. . . ]