User manual ZANUSSI ZT1014

[. . . ] WASHING MACHINE ZT 1014 PROGRAMMES ON-OFF QUICK WASH RINSE HOLD PLUS HALF LOAD AQUACYCLE ZT 1014 132996170 INSTRUCTION BOOKLET GB Important Safety Information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is supplied with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant warnings. These warnings have been provided in the interest of safety. You MUST read them carefully before installing or using the appliance. Installation I I Use I I I I I I I This appliance is heavy. [. . . ] Never remove the filter during a wash cycle, always wait until the appliance has finished the cycle, and is empty. When replacing the filter, ensure it is securely retightened so as to stop leaks and young children being able to remove it. The water inlet filters If your water is very hard or contains traces of lime deposit, the water inlet filters may become clogged. It is therefore a good idea to clean them from time to time. Clean the filters using a hard bristle brush. Tighten up the inlet hoses. P1090 17 Something Not Working Certain problems are due to lack of simple maintenance or oversights, which can be solved easily without calling out an engineer. Before contacting your local Zanussi Service Force Centre, please carry out the checks listed below. IMPORTANT: if you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation, a charge will be made even if the appliance is under guarantee. Symptom The machine does not start Possible causes I I I I I I The door has not been closed. The plug is not properly inserted in the power socket. There is no supply at the socket The main fuse or the fuse in the plug has blown. The selector dial is not correctly positioned. The ON/OFF button has not been depressed. The filters in the inlet hoses are blocked. The inlet hoses may be squashed or kinked. The end of the drain hose is submerged in water. There is no vent in the end of the drain hose. The drain hose may be squashed or kinked. The RINSE HOLD PLUS option has been selected. The drain hose extension, if fitted, is not correct. Follow the instructions for connecting to the waste. The wash load is unbalanced: redistribute the clothes inside the drum to allow the machine to spin. Too much detergent or unsuitable detergent has been used (creates too much foam). Check whether there are any leaks from one of the inlet hose(s) fittings. [. . . ] To align the door perfectly it is necessary to loosen the screw (3-Fig. B), adjust the door and tighten the screw again. d) Counter-magnet (6) The appliance is pre-arranged for a magnetic closure of the door. To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door. [. . . ]