User manual ZANUSSI ZT132-3

[. . . ] ¥ La parte posterior del aparato debe recibir una circulaci--n de aire suficiente y se debe evitar cualquier da­o al circuito refrigerante. 2222607-17 Asistencia ¥ Cualquier modificaci--n que eventualmente fuese necesaria a la instalaci--n elZctrica domZstica para poder instalar el aparato tiene que ser realizada s--lo por personal competente. ¥ Para eventuales intervenciones dirigirse a un Centro de Asistencia TZcnica autorizado y exigir las piezas de repuesto originales. ¥ En caso de necesitar reparaciones no intentar hacerlas personalmente. [. . . ] The glass shelf above the vegetable drawers and the bottle shelf should always remain in position, to ensure correct air circulation. 6 Ice cube production The refrigerator is equipped with one or more ice cube trays, which should be filled with drinking water and placed in the special compartment. Do not use metal implements to detach the trays. Hints Saving Energy ¥ Pay careful attention to where the cabinet is placed. See the section ÒInstallationÓ. When installed correctly the cabinet will consume less energy. ¥ Try to avoid keeping the doors open for long periods or opening the doors too frequently as warm air will enter the cabinet and cause the compressor to switch on unnecessarily often. ¥ If the ambient temperature is high, the thermostat knob is on the coldest setting (higher numbers) and the appliance is fully loaded, the compressor may run continuously, causing frost or ice to form on the evaporator. If this happens, turn the knob to a warmer setting (lower numbers) to allow a saving in electricity consumption. ¥ Do not place warm foods inside the appliance. ¥ Keep the heat emitting condenser, the metall grille on the rear wall of your appliance, always clean. therefore be removed, otherwise there will be a significant reduction in cooling efficiency and an increase in electricity consumption. Turn the thermostat knob on position ÒOÓ, making sure that the stopper of the water collector tray is firmly inserted in the water drain hole; 2. Once defrosted, turn the thermostat knob on a medium position to restart the appliance. The water which has collected in the tray placed under the evaporator must be removed. Place a container on the first shelf in the refrigerator directly under the water drain hole of the defrost tray and remove the stopper as shown in the figure. D188 4. dry thoroughly the ice-compartment and replace the stopper. Never use sharp metal tools to scrape off frost from the evaporator as you could damage it. Do not use a mechanical device or any artificial means to speed up the thawing process other than those recommended by the manufacturer. Hints for refrigeration ¥ Do not store warm food or evaporating liquids in the refrigerator and do cover or wrap up the food, particularly if it has a strong smell. To help you use your refrigerator correctly, here are some useful hints: ¥ Raw meat (beef, pork, lamb & poultry): wrap in polythene bags and place on top of the salad compartment, this being the coldest spot in the refrigerator. Meat can only be stored safely in this way for one or two days at the most. ¥ Cooked food, cold cuts, jelly, etc. : these should be well covered and can be stored on any of the glass shelves. ¥ Fruit & vegetables: these should be thoroughly cleaned and placed in the bottom drawer. ¥ Butter & cheese: these should be placed in special airtight containers or wrapped in aluminium foil or polythene bags to keep out as much air as possible. ¥ Milk bottles: these should have a top and should be stored in the bottle rack on the door. Bananas, potatoes, onions and garlic, if not packed, must not be kept in the refrigerator. Cleaning Never use metal objects for cleaning your appliance as it may get damaged. [. . . ] The Manufacturer declines all responsibility if the above safety precautions are not observed. This appliance complies with the following E. E. C. Directives: - 87/308 EEC of 2/6/87 relative to radio interference suppression. - 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications. [. . . ]