User manual ZANUSSI ZT630T

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. Any plumbing work required to install this appliance should be carried out by a qualified plumber or competent person. s s Care should be taken when cleaning the bottom door seal and hinge area as any exposed metal edges may cut if care is not taken. [. . . ] Larger plates (dinner plates up to 24 cm in diameter) must be loaded in the front part of the upper basket. Light items (plastic bowls etc. ) should be loaded in the upper basket and arranged so they do not move. Before closing the door, ensure that the spray arms can rotate freely. US17 IEC 436 / DIN 44990 Adjusting the height of the upper basket If washing very large plates (over 27 cm and up to 31 cm in diameter) you can load them in the lower basket after moving the upper basket to the higher position. To move to the higher position proceed as follows: 1. Move the front runner stops (A) of the upper basket outward and slide the basket out. Refit the basket in the higher position and replace the stops (A) in their original position. When the top basket is in the higher position it will only take plates up to 20 cm in diameter and you will not be able to use the raised cup racks. After loading your machine always close the door, as an open door can be a hazard. US32 A RC01 11 PBA08GB Hints and tips To save energy Place dishes in the machine immediately after every meal and wait until the dishwasher is full before washing. If necessary run the Rinse and Hold programme (see Programme Chart on the following pages), so that any food scraps do not become caked on the dishes while you are waiting to run the complete wash programme. Do not prewash dishes under running water. Crockery and cutlery A C 55 55 25 g 5g Cold prewash Main wash up to 55°C 1 cold rinse 1 hot rinse up to 65°C Thermal dry ** QUICK 55°C Light soil. Once cleaned refit it following the above instructions in reverse order. Ensure the filter is in its original position, the handle of the drain filter should be pointing towards the front of the appliance. 90° B C MA05 The dishwasher must not be used without filters. Incorrect repositioning and fitting of the filters will produce poor washing results. Cleaning the filters is vital to ensure correct operation of the machine. 15 PMC01GB External cleaning Clean the external surfaces of the machine and control panel with a damp soft cloth. If necessary use only neutral detergents. Never use abrasive products, scouring pads or solvent (acetone, trichloroethylene etc. . . . ). Prolonged periods of non-operation If you are not using the machine for any period of time you are advised to: 1. Unplug the appliance and then turn off the water; 2. Leave the door ajar to prevent the formation of any unpleasant smells; 4. Leave the inside of the machine clean. Frost precautions Avoid placing the machine in a location where the temperature is below 0°C. If this is unavoidable, empty the machine, close the appliance door, disconnect the water inlet pipe and empty it. Moving the machine If you have to move the machine (moving house etc. . . . ): 1. Remove the water inlet and discharge; 4. [. . . ] If necessary, have the domestic wiring system socket replaced. Safety standards require the appliance to be earthed. The manufacture accepts no liability for failure to observe the above safety precautions. This appliance complies with the following E. E. C. Directives: - 73/23 of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; - 89/336 of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. 21 Ø 18 Ø 21 min 30 cm max 100 cm Building-in This dishwasher is designed to be fitted under a kitchen counter or worksurface. [. . . ]