User manual ZANUSSI ZT685

[. . . ] DISHWASHER ZT 685 COP04 152989 03/1 INSTRUCTION BOOKLET GB Important safety information It is most important that this instruction book should be retained with the appliance for future reference. Should the appliance be sold or transferred to another owner, or should you move house and leave the appliance, always ensure that the book is left with the appliance in order that the new owner can get to know the functioning of the appliance and the relevant safety information. This information has been provided in the interest of your safety. You MUST read it carefully before installing or using the appliance. Installation s s s s s s This appliance is heavy. [. . . ] Crockery and cutlery ON OFF ON OFF BIO 50°c 25 g 5g ** QUICK 50°c QUICK 50°c 25 g / * Testing programme according to IEC 436/DIN 44990 Programme "NORMAL 65°c" with detergent type A and programme "BIO 50°c" with detergent type B; Standard place settings: 12. Recommended quantity of detergent: 25 g in the dispenser 5 g in the SID. ** This is a special programme for quick washing (approx. 40 minutes) a full load of lightly soiled crockery etc. 15 PWP09UK Operating sequence 1. Check the filters Ensure they are clean and properly positioned (see cleaning instructions). 9. At the end of the washing programme The dishwasher will automatically stop and an intermittent audible signal of about 5 seconds informs you that the programme has finished. Wait until the end of the signal before opening the door. 2. Check that there is rinse aid and salt 3. Load the dishes Remove any scraps of food. Pull the lower basket out and arrange the saucepans, plates and cutlery in it. Pull the upper basket out and arrange the plates, saucers, glasses and cups etc. Slide the basket back into the machine. 10. Switch off the dishwasher Open the door. The "End of cycle" indicator light flashes. Depress the On/Off button to switch the dishwasher off. 4. Ensure that the spray arms can rotate freely. Measure out detergent Add the required amount of detergent into the dispenser according to the "Washing programmes" chart and close the lid. 11. Cancel the wash programme To change a wash programme in progress depress the button corresponding to the programme you wish to cancel for about 1 second, until the relevant control light goes out. The dishwasher is now reset and you can select a new programme. 6. Select the programme The selection of a programme occurs with the door partially opened. Depress the On/Off button; the On/Off indicator light comes on. Depress the programme button which corresponds to the washing programme you wish to select; the corresponding indicator light will flash. In general it is not advisable to open the door while the machine is working. If the door is opened however, a safety device ensures that the machine stops. [. . . ] It is essential that the recess dimensions indicated in the diagram are followed. No further openings for venting of the dishwasher are required, but only to let the water fill and drain hose and power supply cable pass through. The recess height may be anywhere between 820 and 880 mm from the floor as the dishwasher incorporates adjustable feet (max 60 mm). A distance of 2 mm should be allowed between the top of the dishwasher and the counter top. 5 57 x ma 596 Adjusting the height of the appliance To adjust the height proceed as follows: 1. [. . . ]