User manual ZANUSSI ZTE278

[. . . ] Instruction booklet Condenser Dryer ZTE278 Dear Customer Thank you for choosing one of our high-quality products. With this appliance you will experience the perfect combination of functional design and cutting edge technology. Convince yourself that our appliances are engineered to deliver the best performance and control - indeed we are setting the highest standards of excellence. In addition to this you find environmental and energy saving aspects as an integral part of our products. [. . . ] In both cases the light of the "Start/Pauze" button flashes to remind you that the start button needs to be pressed again. Select the "Startuitstel" With the "Startuitstel" button, you can 16 delay the start of a programme by between 30 minutes (30' and a maximum of 20 hours (20H). 1. Select the programme 2. Press the "Startuitstel" button as many times as necessary until the required start delay appears on the multi display, e. g. 12H if the programme is to be started in 12 hours. If 20H is displayed and you press the button again, the time delay will be cancelled. The display will show 0' and then the duration of the selected programme. 3. To activate the delay timer, press the "Start/Pauze" button. The amount of time remaining until the programme is set to start is continuously displayed (e. g. 12H, 11H, 10H, . . . If you wish to add some laundry while the machine is performing the countdown, after having done so and having closed the door, press "Start/Pauze" again, in order to allow the machine to complete the remaining countdown time. Display The display shows the following information: Duration of selected programme After you have selected the programme, its duration (in hours and minutes) appears on the display. It is calculated automatically on the basis of the maximum load accepted for each type of fabric and of the required degree of drying. 1. 20 When the programme starts, the remaining time is displayed every 5 minutes. Delayed start If you have selected a delay time by means of the relevant button, the display shows it for 3 seconds; then it shows the duration of the previously selected programme. The countdown is displayed every 30 minutes until it displays "90 minutes" and then hour by hour. 3 End of programme A flashing zero indicates the end of the programme and it is displayed after the "anticreasing" phase. 0 Incorrect option selection If you select an option that is not compatible with the programme you have selected, the display shows Err (error). This code will reappear during the execution of the programme if you press one of the option buttons or turn the programme selector. Alarm code In case of a functional anomaly, the display shows an alarm code (e. g. E21). E. 27 Indicator lights These lights indicate the following functions: "Water reservoir full" light "WATERHOUDER " This light comes on at the end of the programme to remind you that the water reservoir must be emptied out. If this light illuminates during a programme this means that the water reservoir is full. The buzzer sounds, the programme stops, the light of the Start/Pause button flashes. "Filter cleaning" light "FILTER" It comes on every 80 cycles to remind you that the condenser must be cleaned. "Condenser cleaning" light "CONDENSOR" This light illuminates at the end of the programme to remind you that the filters must be cleaned. At the end of the programme All drying programmes end with a 10 minute cooling phase. You may remove the laundry after this phase. The lights "FILTER" and "WATERHOUDER ", and illuminate. [. . . ] When operating the tumble dryer, the room temperature must not be lower than +5°C and higher than +35°C, as it may affect the performance of the appliance. Electrical connection This machine is designed to operate on a 230 V, single-phase, 50 Hz supply. Check that your domestic electrical installation can take the maximum load required (2. 35 kW), also taking into account any other appliances in use. Connect the machine to an earthed socket, in accordance with current wiring regulations. [. . . ]