User manual ZANUSSI ZU4150

[. . . ] Important: if the supply cord is damaged, it must be replaced by a special cord or assembly available from the manufacturer or its service agent. There are working parts in this product which heat up. Always ensure that there is adequate ventilation as a failure to do this will result in component failure and possible food loss. Parts which heat up should not be exposed. [. . . ] The minimum setting (least cold) is represented by the lowest number and the maximum setting (coldest) by the highest number. In any case, bear in mind that the temperature can be either increased (warmer) by turning the thermostat knob anticlockwise or decreased (colder) by turning it clockwise. The thermostat knob setting should be adjusted depending on the inner temperature of the refrigerator, which, in turn, depends on a number of factors, such as: the ambient temperature, the number of times the door is opened, the quantity of food stored and the location of the appliance. Warning If the ambient temperature is high, the thermostat knob is on the coldest setting (higher numbers) and the appliance is fully loaded, the compressor may run continuously, causing frost or ice to form on the evaporator. If this happens, turn the knob to a warmer setting (lower numbers) to allow a saving in electricity consumption. 31 Starting-up Insert the plug into the wall socket. Open the door and turn the thermostat control knob, to be found on the upper right hand side of the inner compartment, clockwise beyond position «O» (OFF) to start the appliance. Fresh food refrigeration The refrigerator compartment is suitable for cooling drinks and for normal food storing. To obtain the best performance, do not store warm food or evaporating liquids in the refrigerator and do cover or wrap up the food, particularly if it has a strong smell. Movable shelves The walls of the refrigerator are equipped with a series of runners so that the shelves can be positioned as desired. D040 Positioning the door shelves The short shelf can be adjusted in the direction of the arrows. For more thorough cleaning, the top and bottom door sheves can be removed by pulling them in the direction of the arrows, then refitting them in position. Ice cube production The refrigerator is equipped with one or more ice cube trays, which should be filled with drinking water and placed in the special compartment. Do not use metal implements to detach the trays. 32 HINTS Hints for refrigeration To help you use your refrigerator correctly, here are some useful hints: Cooked food, cold cuts, jelly, etc. : these should be well covered and can be stored on any of the glass shelves. Fruit & vegetables: these should be thoroughly cleaned and placed in the bottom drawer. If the door is open and the light does not come on, check that the bulb is properly screwed in; if it still does not work, replace the bulb with one of the same power. The maximum rating is shown on the light cover. D411 34 SOMETHING NOT WORKING If the appliance is not functioning properly, check that: the plug is firmly in the wall socket and the mains power switch is on; there is an electricity supply (find out by plugging in another appliance); the thermostat knob is in the correct position. If your appliance is still not working properly after making the above checks, contact the nearest service centre. To obtain fast service, it is essential that when you apply for it you specify the model and serial number of your appliance which can be found on the guarantee certificate or on the rating plate located inside the appliance, on the bottom lefthand side. TECHNICAL SPECIFICATIONS The technical data is indicated in the rating plate on the left side inside the appliance. INSTALLATION lf this appliance featuring magnetic door seals is to replace an older appliance having a spring lock (latch) on the door or lid, be sure to make that spring lock unusable before you discard the old appliance. This will prevent it from becoming a death-trap for a child. Important The appliance must be earthed. The power supply cable plug is provided with a contact for this purpose. If the domestic power supply socket is not earthed. connect the appliance to a separate earth in compliance with current regulations, consulting a specialist technician. The Manufacturer declines all responsibility if the above safety precautions are not observed. It must be possible to disconnect the appliance from the mains power supply; the plug must therefore be easily accessible after installation. [. . . ] Should adjustment of the furniture door be necessary, use the clearance of slots. At the end of operations, it is necessary to check if the door of the furniture closes properly. A B C D PR167/1 PR33/2 6. Push cover (C) into guide (A) until it clips into place. 9. Push cover (D) into guide (B) until it clips into place. 8mm A B PR167 7. [. . . ]