User manual ZANUSSI ZU7155

[. . . ] REFRIGERATOR ZU 7155 INSTRUCTION BOOKLET 2222681-34 CONTENTS Instructions for the User Important Safety Instructions Description of the Appliance Operation Before use Setting the temperature Fresh food refrigeration The door shelves Normal Operating Sounds Instructions for the Installer 3 4 5 5 5 5 5 5 Technical Specifications Installation Positioning 14 14 14 The Electrical Connection Grid preparation Right door opening Left door opening Door reversal Building the appliance in under a worktop Fitting the plinth 15 16 16 16 16 17 19 Health and Safety Guidelines Cool Check Guide Positioning of the Cool Check If the Cool Check Shows too Warm 6 7 7 7 Defrosting Maintenance and Cleaning Internal cleaning External cleaning Periodic cleaning Changing the light bulb When the appliance is not in use 7 9 9 9 9 10 10 Something Not Working?Service and Spare Parts Customer Care Department Zanussi Service Force Guarantee Conditions 11 12 12 13 13 2 IMPORTANT SAFETY INSTRUCTIONS These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. If you are unsure about any of the meanings of these warnings contact the Customer Care Department. Prior to Installation s During Use s Check the appliance for transport damage. [. . . ] The appliance should be left overnight and the coolcheck examined in the morning. If the coolcheck shows TOO WARM, turn the appliance to a colder setting leave overnight and examine again the following morning. Hits and tips The guide is only suitable for use in the model supplied. When cleaning the shelf take care not to immerse in water, and wipe away any spills. 7 DEFROSTING The refrigerator automatically defrosts every time the compressor stops. The water is discharged, via the pipe, into a tray located at the back of the appliance above the compressor, where it evaporates. Important To avoid defrost water overflowing and dripping onto the food in the fridge, periodically clean the water discharge hole (F) situated under the vegetable drawers. Use the special cleaner provided (P) which you will find already inserted into the discharge hole P F S. I. 011 MAINTENANCE AND CLEANING Before any maintenance or cleaning work is carried out, DISCONNECT the appliance from the ELECTRICITY supply. An accumulation of dust will affect the performance of the appliance and cause excessive electricity consumption. The structure of the appliance permits to clean the rear zone close to the wall, using a vacuum cleaner. Remove the plinth (1), then the ventilation grid (2); 2. Carefully pull the air deflector out (3), checking that there is no water left from the defrosting. Internal cleaning Clean the inside and accessories with warm water and bicarbonate of soda (5ml to 0. 5 litre of water). NEVER USE DETERGENTS, ABRASIVE POWDERS, HIGHLY PERFUMED CLEANING PRODUCTS OR WAX POLISHES, TO CLEAN THE INTERIOR AS THESE WILL DAMAGE THE SURFACE AND LEAVE A STRONG SMELL. Clean the drain hole of the water trough at regular intervals and make sure that the drain hole is never obstructed, so that the defrost water may flow freely. Important Do not use abrasive products. 3 2 1 S. I. 013 Periodic cleaning The appliance is equipped with an air inlet filter (1) and an air outlet duct (2) on the ventilation grid. Keep clean to guarantee good ventilation and good working order of the appliance. The filter can be removed and washed with water, as follows: 1. In-guarantee customers should ensure that the above checks have been made as the engineer will make a charge if the fault is not a mechanical or electrical breakdown. Please note that proof of purchase is required for any in-guarantee service calls. 9 SERVICE AND SPARE PARTS In the event of your appliance requiring service, or if you wish to purchase spare parts, please contact your local Zanussi Service Force Centre by telephoning:Before calling out an engineer, please ensure you have read the details under the heading `Something Not Working'. When you contact the Service Centre you will need to give the following details. Clear and concise details of the fault 4. of the appliance (found on the rating plate) 5. [. . . ] The grid is to be assembled after having fixed the appliance in the niche with the brackets. S. I. 002 A a B b Door reversal The appliance must be unplugged before starting work. To reverse the opening direction of the door, proceed as follows: 1. remove the top hinge (1) taking care not to let the door fall; 2. take out the plugs (3) from the holes (F) and reinsert them in the holes (F1) on the opposite side; 4. [. . . ]