User manual ZANUSSI ZWF1201

[. . . ] User Manual Washing machine Centrifugeren Centrifugeren Pompen Spoelen Inweken Inweken 30° Gordijnen Gordijnen 40° Sport Spor t 40° intensief Wol 40° Handwas Handwas 30° Handwas Handwas 40° 95° Startuitstel Star tuitstel 60° eco 60° 40° 30° 60° 40° 1300 900 700 500 Spoelstop Centrifugeren Centrifugeren Extra kort kor t Opties Voorwas oorwas 3u 6u 9u Hoofdwas Hoofdwas Spoelen/ Centrifugeren Centrifugeren Einde Extra spoelen Start auze Star t/Pauze 30° 30° Anti-kreuk 40° 40° Anti-kreuk ZWF 1201 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel and functions - - - - - - - - - - - -6 Programme table - - - - - - - - - - - - - - - - - -8-9 Programme information - - - - - - - - - - - - - -10 Washing Hints - - - - - - - - - - - - - - - - - - - - -11 Before the first use - - - - - - - - - - - - - - - - -13 Operating Sequence - - - - - - - - - - - - - - - -14 Care and cleaning - - - - - - - - - - - - - - - - - -17 What to do if. . . [. . . ] Start the new programme by depressing the button 5 again. The washing water in the tub will not empty out. Interrupting a programme Press the button 5 to interrupt a programme which is running, the corresponding light starts to flash. Press the button again to restart the programme. Cancelling a programme Turn the selector dial to «O» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing the button 5. After some minutes, the door can be opened. If the machine is already heating, that the water level is above the bottom edge of the door, the door cannot be opened. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «O». After few minutes the door can be opened (Pay attention to the water level and temperature!). After this procedure, it will be necessary to set the programme and the options again and then press the button 5. The selected delay can be modified only after you have turned the programme selector dial to the «O» position and after you have selected the programme again. The door will be locked throughout the delay time. If you need to open the door, you must first set the washing machine to PAUSE by pressing the button 5 and wait few minutes before opening the door. After you have closed the door, press the button 5 again. Note!The Delay Start cannot be selected with DRAIN programme. 15 At the end of the programme The machine stops automatically. The pilot light of button 5 goes off while the phase light C illuminates. If at the end of a programme there is water in the tub, to empty out the water follow the following instructions: turn the programme selector dial to «O» select the DRAIN or SPIN programme reduce the spin speed if needed, by means of the relevant button press button 5 At the end of the cycle, turn the programme selector dial to «O» to switch the machine off. Remove the laundry from the drum and carefully check that the drum is empty. If you do not intend to carry out another wash, close the water tap. Leave the door open to prevent the formation of mildew and unpleasant smells. 16 Care and cleaning IMPORTANT!You must DISCONNECT the appliance from the electricity supply, before you can carry out any cleaning or maintenance work. Descaling The water we use normally contains lime. [. . . ] Set the hose correctly by loosening the ring nut. After positioning the inlet hose, be sure to tighten the ring nut again to prevent leaks. Connect the hose to a tap with a 3/4" thread. Always use the hose supplied with the appliance. In a sink drain pipe branch. [. . . ]