User manual ZANUSSI ZWH6120

[. . . ] User Manual Washing machine ZWH 6100 ZWH 6100 A ZWH 6120 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel and functions - - - - - - - - - -6-7 Programme table - - - - - - - - - - - - - - - - -9-10 Programme information - - - - - - - - - - - - - -11 Washing Hints - - - - - - - - - - - - - - - - - - - - -12 Before the first use - - - - - - - - - - - - - - - - -14 Operating Sequence - - - - - - - - - - - - - - - -15 Care and cleaning - - - - - - - - - - - - - - - - - -18 Something not working - - - - - - - - - - - - - - 20 Technical data- - - - - - - - - - - - - - - - - - - - - 23 Consumption values - - - - - - - - - - - - - - - - 24 Installation instruction - - - - - - - - - - - - - - - 25 Environmental concerns - - - - - - - - - - - - - 28 Guarantee - - - - - - - - - - - - - - - - - - - - 29-30 2 Safety information In the interest of your safety and to ensure the correct use, before installing and first using the appliance, read this user manual carefully, including its hints and warnings. [. . . ] The incorrect option selection is indicated by the message Err displayed for few seconds and by flashing of the red light button 8. In the event of operating problems, some alarm codes can be displayed, (see paragraph "Something not working"). E20 The End of programme is indicated by a flashing zero «0». 0 16 Altering an option or a running programme It is possible to change any option before the programme carries it out. Before you make any change, you must pause the washing machine by pressing button 8. Changing a running programme is possible only by resetting it. Turn the programme selector dial to«Off» and then to the new programme position. Start the new programme by depressing button 8 again. The washing water in the tub will not empty out. Interrupting a programme Depress tbutton 8 to interrupt a programme which is running, the corresponding light starts to flash. Depress the button again to restart the programme. Cancelling a programme Turn the selector dial to «Off» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing the button 8. If the light «Door» goes off, the door can be opened. If it does not switch off, this means that the machine is already heating, that the water level is above the bottom edge of the door. In this cases the door cannot be opened. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «Off». After few minutes the door can be opened (Pay attention to the water level and temperature!). After this procedure, it will be necessary to set the programme and the options again and then to depress button 8. At the end of the programme The machine stops automatically. Some acustic signals sound and on the display will appear a flashing «0 ». The button 8 light and the light «Door» go off. If at the end of a programme there is water in the tub (the Door light is on), to empty out the water follow the following instructions: To empty out the water: 1. turn the programme selector dial to «Off» 2. select the Drain»or «Spin» programme 3. [. . . ] Should the appliance power supply cable need to be replaced, this MUST be carried out by our Service Centre. NOTE Please ensure that when the appliance is installed it is easily accessible for the engineer in the event of a breakdown. 27 Environmental concerns Packaging materials The materials marked with the symbol are recyclable. >PE<=polyethylene >PS<=polystyrene >PP<=polypropylene This means that they can be recycled by disposing of them properly in appropriate collection containers. Old machine Use authorised disposal sites for your old appliance. [. . . ]