User manual ZANUSSI ZWI1125

[. . . ] User Manual Washing machine Centrifugeren Centrifugeren Pompen Spoelen Inweken Inweken 30° Gordijnen Gordijnen 40° Sport Spor t 40° intensief Wol 40° Handwas Handwas 30° Handwas Handwas 40° 95° Startuitstel Star tuitstel 60° eco 60° 40° 30° 60° 40° 1300 900 700 500 Spoelstop Centrifugeren Centrifugeren Extra kort kor t Opties Voorwas oorwas 3u 6u 9u Hoofdwas Hoofdwas Spoelen/ Centrifugeren Centrifugeren Einde Extra spoelen Start auze Star t/Pauze 30° 30° Anti-kreuk 40° 40° Anti-kreuk ZWI 1125 Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel and functions - - - - - - - - - - - -6 Programme table - - - - - - - - - - - - - - - - - -8-9 Washing Hints - - - - - - - - - - - - - - - - - - - - -10 Before the first use - - - - - - - - - - - - - - - - -12 Operating Sequence - - - - - - - - - - - - - - - -13 Care and cleaning - - - - - - - - - - - - - - - - - -16 What to do if. . . [. . . ] Use a normal measure of detergent, must be a powder with biological properties. External cleaning Clean the exterior cabinet of the appliance with soap and water only, and then dry thoroughly. Cleaning the dispenser drawer The washing powder and additive dispenser drawer should be cleaned regularly. Remove the drawer by pressing the catch downwards and by pulling it out. Flush it out under a tap, to remove any traces of accumulated powder. Cleaning the drawer recess Having removed the drawer, use a small brush to clean the recess, ensuring that all washing powder residue is removed from the upper and lower part of the recess. Replace the drawer and run the rinse programme without any clothes in the drum. To aid cleaning, the top part of the additive compartment should be removed. 16 Cleaning the pump The pump should be inspected if the machine does not empty and/or spin the machine makes an unusual noise during draining due to objects such as safety pins, coins etc. Proceed as follows: Disconnect the appliance. If necessary wait until the water has cooled down. Place a container close to the pump (A) to collect any A spillage. B Pull out the emergency emptying hose (B), place it in the container and remove its cap. When no more water comes out, unscrew the pump cover and remove it. Always keep a rag nearby to dry up spillage of water when removing the cover. Remove any objects from the pump impeller by rotating it. Put the cap back on the emergency emptying hose and place the latter back in its seat. The dangers of freezing If the machine is exposed to temperatures below 0°C, certain precautions should be taken. Place the end of the emergency emptying hose and that of the inlet hose in a bowl placed on the floor and let water drain out. Screw the water inlet hose back on and reposition the emergency emptying hose after having put the cap on again. When you intend to start the machine up again, make sure that the room temperature is above 0°C. Every time you drain the water through the emergency emptying hose you must pour 2 litres of water into the main wash compartment of the detergent drawer and then run the drain programme. This will activate the ECO VALVE device avoiding that part of the detergent remains unused at next washing. Emergency emptying out If the water is not discharged, proceed as follows to empty out the machine: pull out the plug from the power socket; close the water tap; if necessary, wait until the water has cooled down; place a bowl on the floor and place the end of the emergency emptying hose into the bowl. The water should drain by gravity into the bowl. [. . . ] To enable a correct operation of this device, it is necessary to screw the counter-magnet (6) (steel disk + rubber ring) into the inner side of the door. Its position must correspond to the magnet (4) on the appliance (see picture D). 416 818 1 1 2 7 3 5 B 23 8 a) Door The dimensions of the door should be: - width 595-598 mm - thickness 16-22 mm The height (C-Fig. C) depends on the height of the adjacent furniture's base. 26 416 C 22+1 , 5 B 195 6 4 Position the base into the recess with its front edge as far forward as the adjoining plinth line will allow. The reason for placing the base in this position is to allow a small strip of beading to be fitted in front of the appliance feet. [. . . ]