User manual ZANUSSI ZWK5120

[. . . ] The glass cover (only on some models), before lighting the over burners of the top and until their turning off, shall be in open position; it is important to avoid any contact with cookware during the cooking in order to save from a dangerous overheating. MODELS SPECIFICATIONS Fig. 1 a2 B a1 100 a2 C1 C2 B a1 100 Important After the cooker use it is recommended to: 1) always check that the knobs are in the " " position. 2) close the cock of the gas cylinder (if you use liquefied gas) or the supply cock (in case of natural gas). 3) periodically check the wear of the hosepipe and replace it if necessary. [. . . ] 11) - Take away the burners caps, caps and support grids - Lift up the cook-top - Unscrew the screws of the control panel and remove it. - Unscrew both screws fixing the cover ( A fig. 12 - 12/a) - Extract the plug of the cock. - Clean accurately both the plug and its seat GB Fig. 15/B 5 USE OF ACCESSORIES Timer Your range can be fitted with this accessory that you can wind by rotating the corresponding knob clockwise by one complete turn and set the pointer to the desired cooking time (expressed in minutes) by rotating the knob counterclockwise. The set time running out will be signaled by a bell. Electric timer Your range can be fitted with this accessory acting both as a clock and as a timer as well. To set hour push and rotate the small knob counterclockwise. To set minutes rotate the small knob counter clockwise without pushing it. Timer with cooking end function Your range can be fitted with this double functional accessory: it can show the cooking time that has already passed and automatically turn off the oven. You can set the desired cooking time by rotating the timer knob clockwise by one complete turn and set the pointer to the desired cooking time (expressed in minute); when this time has passed the acoustic warning signal switches on and contemporaneously the automatic cooking end device starts. Half-automatic working mode (cooking time) By pushing button 2 and setting the cooking time by means of button 5, both the "AUTO" and the symbol will lit up. When the set time has run out, the symbol will switch off while the "AUTO" symbol flashes and the acoustic warning signal starts. Half-automatic working mode (end of cooking time) By pushing button 3 and setting the end of cooking time by means of button 5, both the "AUTO" and the symbols will lit up. When the set time has run out, the symbol will switch off while the "AUTO" symbol flashes and the acoustic warning signal starts. Automatic working mode (postponed cooking start time) First you should set your cooking time (both the "AUTO" and the symbols will lit up) and then the cooking end time, the symbol will switch off as previously stated. The symbol will lit up again when the oven starts baking. When cooking time has run out, the symbol will switch off while the "AUTO" symbols flashes and the acoustic warning signal starts. Manual working Manual working is possible only after having cleared the automatic program by pushing button 3. The "AUTO" symbol disappears and no other symbols lit up. Acoustic warning signal The acoustic warning signal starts at the end of a program and lasts about two minutes. To interrupt it you should push one of the function buttons. [. . . ] If the flame is not uniform around the burner it means that there is excess of air; if it presents yellow points there is black of air. A well-regulated flame shall be not so luminous and light blue. For the regulation act on the rings (fig. 23) in order to obtain the opening stated in the following table. BEFORE CALLING THE AFTER-SALES SERVICING CENTRE If the appliance does not function correctly, before turning to after-sales servicing centre check the following: The gas flux is not regular. [. . . ]