User manual ZANUSSI ZWW9570W

[. . . ] User manual Washerdryer ZWW 9570 W Thank you for selecting our appliance We wish you lots of enjoyment with your new appliance and we hope that you will consider our brand again when purchasing household appliances. Please read this user manual carefully and keep it throughout the product life cycle as a reference document. The user manual should be passed on to any future owner of the appliance. The following symbols are used in this manual: Important information concerning your personal safety and information on how to avoid damaging the appliance. General information and tips Environmental information Content Safety information - - - - - - - - - - - - - - - - - - -3 Description of the appliance - - - - - - - - - - - -5 Detergent dispenser drawer - - - - - - - - - - - -5 Control panel - - - - - - - - - - - - - - - - - - - - - -6 Display - - - - - - - - - - - - - - - - - - - - - - - - - - -8 Functions - - - - - - - - - - - - - - - - - - - - - - - - -9 Programme table - - - - - - - - - - - - - - - - - -10 Programme information - - - - - - - - - - - - - -12 Washing and drying hints - - - - - - - - - - - - -13 Before the first use - - - - - - - - - - - - - - - - -16 Operating Sequence - - - - - - - - - - - - - - - -16 2 Washing - - - - - - - - - - - - - - - - - - - - - - - - -16 Drying - - - - - - - - - - - - - - - - - - - - - - - - - -19 Drying programmes - - - - - - - - - - - - - - - - -21 Care and cleaning - - - - - - - - - - - - - - - - - -22 What to di if. . . [. . . ] If you have chosen a delayed start, the machine will begin the countdown. IMPORTANT!If an option which is not compatible with the set wash programme is selected, the message Err is displayed for a few seconds and the red light of this button flashes for 3 times. Altering an option or a running programme It is possible to change the options before the programme carries it out. Before you make any change, you must pause the machine by pressing button 8 . Changing a running programme is possible only by resetting it. Turn the programme selector dial to «O» and then to the new programme position. Start the new programme by pressing button 8 again. The washing water in the tub will not empty out. Interrupting a programme Press button 8 to interrupt a programme which is running, the corresponding light starts to flash. Press the button again to restart the programme. Cancelling a programme Turn the selector dial to «O» to cancel a programme which is running. Opening the door after the programme has started First set the machine to pause by pressing button 8 . If the door is still locked, this means that the machine is already heating, that the water level is above the bottom edge of the door. If you cannot open the door but you need to open it you have to switch the machine off by turning the selector dial to «O». The door can be opened after a few minutes. (Pay attention to the water level and temperature!). 18 After this procedure, it will be necessary to set the programme and the options again and then to press button 8 . At the end of the programme The washer dryer stops automatically. Some acustic signals sound and on the display will appear three flashing «0. 00 ». If, at the end of a programme, there is water in the tub, to empty out the water follow the following instructions: To empty out the water proceed as follows: 1. turn the programme selector dial to «O» 2. select the Drain»or «Spin» programme 3. reduce the spin speed, if needed, by pressing button 3 4. [. . . ] The appliance is supplied with a 13amp plug fitted. In the event of having to change the fuse in the plug supplied, a 13amp ASTA approved (BS1363/A) fuse must be used. Should the plug need to be replaced for any reason, proceed as described below. The wires in the mains lead are coloured in accordance with the following code: Green and Yellow . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . - Earth Blue . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . - Neutral Brown. . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . - Live N L 13 A BROWN BLUE CORD CLAMP The wire coloured brown must be connected to the terminal marked «L» or coloured red. [. . . ]