User manual ZANUSSI ZX59WIS

[. . . ] It is dangerous to alter the specifications or attempt to modify this product in any way. Care must be taken to ensure that the appliance does not stand on the electrical supply cable. Important: if the supply cable is damaged, it must be replaced by a special cable available from your local Service Force Centre. Any electrical work required to install this appliance should be carried out by a qualified electrician or competent person. [. . . ] Only ASTA or BSI approved fuses should be used. The plug must not be used if the fuse cover/carrier is lost. The cover/carrier is indicated by the coloured insert at the base of the plug. A replacement cover/carrier must be obtained from your local Zanussi Service Force Centre. 87/308 of 2. 6. 87 relative to radio interference suppression. This appliance complies with the following E. E. C. Directives: 73/23 EEC of 19. 2. 73 (Low Voltage Directive) and subsequent modifications; 89/336 EEC of 3. 5. 89 (Electromagnetic Compatibility Directive) and subsequent modifications. Freezing fresh food When freezing fresh foods set the slider control to the "cold" position and turn the thermostat control to a higher setting. In any 24 hours you can freeze up to 6 kg. Place food to be frozen in the upper drawer of the freezer as this is the coldest part. After 24 hours reposition the slider control and thermostat control to previous setting. Important To ensure correct operation of the appliance do not use the appliance with the basket or drawers removed. Frozen food storage Frozen food can be stored in any basket or drawer of the freezer compartment, including the fast freeze compartment. There must also be at least 100 mm (4") distance between the top of the cabinet and any overhanging kitchen furniture (A). Ideally, the appliance should not be positioned beneath overhanging furniture (B). There should also be a gap of 25 mm either side of the appliance. Do not obstruct the space underneath. NP00 Defrost water drips into the drain pan during the defrost cycle. Water dropping on the defrost heater causes a hissing or popping sound during the defrost cycle. The automatic defrost timer sounds like an electric clock and clicks in and out of the defrost cycle. The compressor will make a humming or pulsating sound while operating. A 45° PR60 Rear spacers The plastic bag containing all relevant documentation also contains two spacers to be fitted into special holes in the back of the appliance. Fit the spacers into the holes, taking care to ensure that the arrow (A) is positioned as shown in the diagram. Then turn them through 45° (arrow (A) vertical) until they lock into place. DO NOT install in places with restricted ventilation. Adjust the level of the appliance by screwing out the adjustable foot, or feet, at the bottom of the cabinet using your fingers. 14 D200 7 HEALTH AND SAFETY GUIDELINES Because of consumer demand, preservatives have been removed from many pre-prepared foods. [. . . ] You MUST ensure that the appliance is switched OFF. Once or twice a year dust the condenser (black grill) and the compressor at the back of the appliance, with a brush or vacuum cleaner, see figure. D613 Unscrew the light cover and then pull it outward by pressing as shown in the figure. Unscrew the bulb and replace it with a new 15 watt bulb (available from your nearest Service Force Centre). Replace the light cover by sliding it into its original position and replacing the screw. Automatic Defrosting Your appliance has been designed to be frost free. [. . . ]