User manual ZANUSSI ZX79-5SI

[. . . ] REFRIGERATOR - FREEZER ZX77/3 ZX77/5 ZX79/3 ZX79/5 INSTRUCTION BOOKLET 214. 3660. 55 Contents Instructions for the User Safety Instructions Description of the Appliance Control Panel Using the Appliance Before Use Starting the Appliance Freezer Compartment Freezing Fresh Food Frozen Food Storage Refrigerator Compartment Chill Compartment Food Storage Energy Saving Advice In the Event of a Power Failure Maintenance and Cleaning Something Not Working Normal Operating Sounds Service & Spare Parts Customer Care Department Guarantee Conditions Zanussi Service Force 2 3 4 5 5 5 5 5 5 5 5 6 6 6 7 8 9 9 9 10 11 - 12 Instructions for the Installer Technical Specifications Installation Unpacking Positioning Ventilation Leveling Electrical Connection Electrical Requirements Changing the Opening direction of the Doors 13 14 14 14 14 14 15 15 16 1 Safety Instructions These warnings are provided in the interests of your safety. Ensure that you understand them all before installing or using this appliance. If you are unsure of the meanings of these warnings contact the Customer Care Department. Installation This appliance is heavy. It is dangerous to alter the specifications or attempt to modify this product in any way. [. . . ] Do not put any hot food into the fridge or freezer. This will ensure safer defrosting of foods and reduce the work of the refrigeration unit. Try to avoid keeping the door open for long periods, or opening the door too frequently as warm air will enter the cabinet, and cause the compressor to switch on unnecessarily often. Ensure there are no obstructions preventing the door from closing properly. To obtain the best results from your appliance, neither hot foods nor liquids, which may evaporate should be placed in the larder compartment. Avoid buying frozen food if you cannot store it straight away. The use of an insulated container is advisable. When you arrive home place the frozen food in the freezer immediately. Keep the time between buying chilled food and placing it in your fridge as short as possible. Do not push food together too much; try to allow air to circulate around each item. Wrap the food up properly or place it in airtight containers before putting it into the fridge freezer. 6 Ensure that food placed in the freezer is dated and labeled and used in date order to ensure that food is consumed at its best. Remove suspect food from your fridge freezer and clean, refer to Maintenance and Cleaning. Switch off the appliance and leave the door ajar to prevent unpleasant smells. When the appliance is not in use Cleaning the Condenser The Condenser at the bottom of your appliance needs to be cleaned periodically. Remove the plinth, and clean with a vacuum cleaner. Ensure the plinth is replaced after cleaning. Glass Shelves The shelf on the vegetable drawer is secured by two tabs. To release and remove the vegetable drawer and glass shelf, it is necessary to rotate the tabs as shown in detail B (Tabs A are previously removed transit packaging). NOISE REDUCTION PAD (DONT REMOVE) 7 Something Not Working If your appliance is not operating correctly, carry out the following checks before contacting your local Service Force Centre. Important: If you call out an engineer to a fault listed below, or to repair a fault caused by incorrect use or installation a charge will be made, even if the appliance is under guarantee. Symptom Interior Light (refrigerator) does not work Cause Appliance is not plugged in The appliance is not switched on There is no power to the appliance The bulb is not fitted correctly or has fused. Solution Plug in the appliance Switch on the appliance Check the main fuse box in the house Refit the bulb or replace with a new bulb Close the doors Avoid frequent opening of the doors Reset as required The appliance will cool down in due course. Reset as required Reposition food, leaving a gap. Change the setting Close the doors Avoid frequent opening of the doors The appliance will cool down in due course. Clean (read the Maintenance & Cleaning section). This may occur from time to time It does not affect the performance of the appliance. [. . . ] 4) Leveling Level the appliance by turning the 2 adjustable feet at the front of the appliance. The appliance must be level to prevent vibration and excessive noise and to ensure the doors shut correctly. 5 14 Electrical Connection Any electrical work required to install this appliance must be carried out by a qualified electrician or competent person. The manufacturer declines any liability should these safety measures not be observed. Electrical Requirements Before switching on, make sure the electricity supply voltage is the same as that indicated on the appliance rating plate. [. . . ]