User manual ZEKTOR CLARITY ELITE 8X8

[. . . ] Clarity Elite 8x8 Component Video / Audio Matrix Switch 2 Clarity Elite 8x8 User Guide, Version 1. 5a, 10/2/09 What's Inside. . 8 Turning the Clarity Elite 8x8 on or off. 9 Volume, Balance, Tone Controls and Gains . 13 Using Presets - Selecting a Preset, and Toggling "Client Mode" . [. . . ] You can turn off zones that you don't want affected by the preset, by pressing a zone button F . Each zone's video and audio setting are turned on/off individually. The VID / AUD LEDs indicate whether you are viewing the video mappings, or the audio mappings. When a zone LED has its decimal point lit, this indicates the audio and video settings do not match (one of the audio or video settings is turned off, while the other is turned on). Toggle the the VID / AUD LEDs using the VID/AUD button E to choose between the video/audio settings. To completely turn off a zone's video and audio (so that the preset will have no affect on the zone), you must turn off the zone while the VID LED is lit, toggle the VID/AUD LED, and then turn off the zone while the AUD LED is lit. The decimal point will also turn off, indicating both the VID and AUD selections match. 4 Once all zones you want to change are lit up, (and likewise all zones you don't want affected by the preset are turned off), press the ENT D button. The display will now prompt you to choose which preset you want to program. Use the source buttons C to enter the number of the preset you want to program. Use the CLR button B to enter a `0'. Use the VID/AUD toggle button E to enter a `9'. The presets 01-20 are available on the front panel, the next section shows you how the preset numbers of each front panel button, are mapped. 5 Once the desired preset is being displayed, press the ENT button D to save the new configuration into the displayed preset. Clarity Elite 8x8 User Guide, Version 1. 5a, 10/2/09 13 Front Panel Commands Using Presets - Selecting a Preset, and Toggling "Client Mode" G AUDIO VIDEO MATRIX SWITCH MEM 1 2 3 4 VID AUD 1 2 3 4 5 6 7 8 CLR 5 6 7 8 ENT A B C D E F Once presets have been setup, using the preset is a simple manner of prefixing any button with the MEM button. To select a new preset: 1 2 Press the MEM button G . The VID / AUD LEDs will start blinking, indicating the Clarity Elite 8x8 is waiting for a preset. Now pressing any button on the front panel, except power, will recall the configuration memorize by that preset. Pressing the power button A will cancel the preset mode and nothing will be changed. The front panel buttons are mapped to the presets as follows: · · · · · · Input buttons 1-8 C are mapped as presets 01-08. Zone buttons 1-8 F are mapped as presets 11-18. The CLR button B is preset 20. 3 Another way of using the front panel buttons as presets is to enter the Client Mode. The Client Mode locks the front panel into a mode where every button is a preset. [. . . ] 480i - 1440p60, all HDTV modes, includes 1080p24 & 1080p60 Input impedance. . 75 ohms Analog Audio Analog inputs . 8 Left / Right RCA connector pairs Analog outputs . 8 Left / Right RCA connector pairs Bandwidth. [. . . ]