User manual ZENITH CM-148-GX

[. . . ] This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures: - Reorient or relocate the receiving antenna. - Increase the separation between the equipment and receiver. [. . . ] Note that this setting is cleared when the monitor is turned off. Press the SLEEP button repeatedly to select the number of minutes. First the --- Min option appears on the screen, followed by the following sleep timer options: 10, 20, 30, 60, 90, 120, 180, and 240 minutes. When the number of minutes you want is displayed on the screen, press the OK button. The timer begins to count down from the number of minutes selected. To check the remaining minutes before the monitor turns off, press the SLEEP or OK button once. To cancel the Sleep Timer, press the SLEEP button repeatedly until zz zz --- Min appears. 18 Plasma Display Operation Special Menu Options Key Lock - The monitor can be set up so that it can only be used with the remote control. - This feature can be used to prevent unauthorized viewing by disabling the front panel controls. - This Monitor is programmed to remember which option it was last set to even if you turn the monitor off. Press the G D /E button to select the SPECIAL menu. VIDEO AUDIO TIME SPECIAL Language Key lock ISM Method Low power Set ID OSD Rotate G button and then use D /E button to select Key lock. On Off 3. Press the G button and then use D /E button to select On or Off. W Key lock' · When you select On, the display ` on the front panel is pressed. After adjustment, if the image is still not correct, your Monitor is functioning properly but needs further adjustment. are not available for DVI mode. D /E 1. Press the G button to select the SCREEN menu. VIDEO AUDIO TIME SPECIAL SCREEN TWIN Auto config. Reset XGA Mode G To set button and then use D /E button to select Auto config. . 3. Press the G button to run Auto configure. has finished, OK will appear on the screen. · If the position of the image is still not correct, try Auto adjustment again. In RGB (PC) mode, if the image needs to be adjusted more after using Auto config. , you can make further adjustments with the Manual config. option. MENU Prev. Setting Picture Format - Caution: If a 4:3 fixed image is shown with gray bars at the sides of the screen for a long time, the gray images may remain visible. - All aspect ratio for RGB 480p, DVI 480p, Component 480i/480p, Video, and S-Video sources are shown below. - Use 4:3, or 16:9 for other input sources. [. . . ] This warranty gives you specific legal rights and you may also have other rights that vary from stat to state. THIS LIMITED WARRANTY DOES NOT APPLY TO: q q HOW SERVICE IS HANDLED: In Home Service. Please Call the Zenith Interactive Center at 1-877-9ZENITH (1-877-993-6484) to schedule a service appointment. Your unit will be repaired or replaced with a new, substitute model or factory reconditioned unit, at Zenith's option. [. . . ]