User manual ZENITH DSV100 OPERATING GUIDE

[. . . ] DSV-110 operating guide Presentation Series DSV-100 WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN IMPORTANT SAFETY INSTRUCTIONS Important safeguards for you and your new product Your product has been manufactured and tested with your safety in mind. However, improper use can result in potential electrical shock or fire hazards. To avoid defeating the safeguards that have been built into your new product, please read and observe the following safety points when installing and using your new product, and save them for future reference. Observing the simple precautions discussed in this booklet can help you get many years of enjoyment and safe operation that are built into your new product. [. . . ] 5 The projector will now automatically dis. play the pictures from the video source. If not, see the section `What do I do if'. Figure 6: Connecting to video sources 12 13 4. 1 Using external speakers In order to use external speakers with the projector you will need an amplifier. Connect the amplifier to the audio out on the projector. 5. Connecting a TV-source to the projector A TV-tuner is optional for the projector (Please consult your Zenith dealer for availability of this option). These three work differently and it is important to consider the options of each when adjusting the projector settings. 6. Using Your Zenith projector 6. 1 Different program modes for your Zenith projector The projector has the following modes of operation: · Stand-by mode · Normal mode · Quick mode · Menu mode · Pointer mode · Blank mode Antenna When you adjust your TV to signals from an antenna you must store each channel in a different program. The same is true for the projector TV-tuner. When connected to an antenna you assign the different channels to the programs in the Television Setup Menu. Then you use the Up and Down arrows in the menu, remote control or the channel up/down button on the control panel to switch between channels. Cable When you are connected to a cable system you have two options. If you have a cable decoder, you will set your TV to the channel for the cable, and then use the remote control for the decoder to switch between channels. If you do not have a decoder you simply set your TV up just like you would with an antenna. This is also the same with the Zenith projector. You must scroll the channel name in the TV Settings menu until you find the correct channel for your cable system. When this channel has been assigned to one of the program numbers you simply select this program and use the remote control or control panel to switch between channels. Stand-by mode (see section 6. 3) In stand-by mode the projector is turned off and can be turned on by using defined keys. Figure 7: Using external speakers When external speakers are connected, these can be turned on or off from the projector. To control the internal speakers, see the section on adjusting audio settings, section 7. 3. 2. Normal mode In normal mode a picture will be shown on the screen. The mouse will function as a normal PC mouse. Figure 8: Connecting to TV- source Note: Requires TV tuner to be installed. In order to use the projector as a TV output; connect the TV antenna to the TV connector on the projector plug panel. The projector behaves just like a normal TV. See the menus section 7. 2. 7 on how to adjust the TV settings. There are basically three ways of receiving the TV signals to the projector: Quick mode (see section 7. 2. 4) Quick mode is used with the interactive remote control (quick key). You assign functionality for the quick key on the remote control in the quick menu (see section 7. 2. 5). When clicking on the Quick key you will be able to switch between all the functions you have selected in this menu. Satellite This works similar to the cable decoder. [. . . ] Activate the external port on the laptop by pressing the required key combination on your computer. The projector is not connected to electricity. Check that the power cable is connected to the projector and the wall outlet. in the wall. Check that there is power in the power outlet. [. . . ]