User manual ZENITH P42W34P OPERATING GUIDE

[. . . ] Installation and Operating Guide Model Number | P42W34P | PLASMA DISPLAY PANEL © Copyright 2003, Zenith Electronics Corporation. Warning Warning WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO PREVENT FIRE OR SHOCK HAZARDS, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. FCC NOTICE · A Class B digital device This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. [. . . ] button to set the minutes. -- : -- Auto off 5. Press the ENTER button to save. MENU Prev. On/Off Timers Setup On/Off - Timer functions operate only if current time has been set. - Off-Timer function overrides On-Timer function if they are set to the same time. - The monitor must be in standby mode for the On-Timer to work. Press the G D /E button to select the TIMER menu. TIMER Clock Off timer On timer Auto off G button and then use D /E button to select Off timer or On timer. 3. Press the G button and then use D / E button to select On. · To cancel On/Off timer function, select Off. 30 button and then use button and then use D /E D /E button to set the hour. For only On timer function; Press the sound level. Press the ENTER button to save. button and then use D /E button to set MENU Prev. Auto Off Off - If there is no input signal, the Monitor will turn off automatically after 10 minutes. Press the G button and then use D /E D /E D /E TIMER Clock Off timer On timer Auto off G button to select the TIMER menu. button to select Auto off. button to select On or Off. On Off 4. Press the ENTER button to save. MENU Prev. Sleep Timer - The Sleep Timer turns the Monitor off at the preset time. Note that this setting is cleared when the monitor is turned off. Press the SLEEP button repeatedly to select the number of minutes. First the screen, followed by the following sleep timer options: 10, 20, 30, 60, 90, 120, 180, and 240 minutes. zz --- Min option appears on the 2. When the number of minutes you want is displayed on the screen, press the ENTER button. The timer begins to count down from the number of minutes selected. To check the remaining minutes before the monitor turns off, press the SLEEP or ENTER button once. To cancel the Sleep Timer, press the SLEEP button repeatedly until zz --- Min appears. 18 Plasma Display Special Menu Options Key Lock - The monitor can be set up so that it can only be used with the remote control. - This feature can be used to prevent unauthorized viewing by disabling the front panel controls. - This Monitor is programmed to remember which option it was last set to even if you turn the monitor off. [. . . ] Transmission [j][t][ ][Set ID][ ][Data][Cr] Data Min: 0 ~ Max: 64 · Refer to `Real data mapping 1'. Acknowledgement [t][ ][Set ID][ ][OK][Data][x] 27. ISM Method (Command2:p) G To avoid having a fixed image remain on screen. Transmission [j][p][ ][Set ID][ ][Data][Cr] Data 0: Normal 1: White wash Acknowledgement [p][ ][Set ID][ ][OK][Data][x] 2: Orbiter 3: Inversion G To adjust picture position and minimize image shaking automatically. [. . . ]