User manual ZENITH VCP353

[. . . ] machine numbers VCP353 thanks for choosing zenith SAFETY WARNINGS WARNING RISK OF ELECTRIC SHOCK DO NOT OPEN WARNING: TO REDUCE THE RISK OF ELECTRIC SHOCK DO NOT REMOVE COVER (OR BACK). The lightning flash with arrowhead symbol, within an equilateral triangle, is intended to alert the user to the presence of uninsulated "dangerous voltage" within the product's enclosure that may be of sufficient magnitude to constitute a risk of electric shock to persons. The exclamation point within an equilateral triangle is intended to alert the user to the presence of important operating and maintenance (servicing) instructions in the literature accompanying the appliance. WARNING: TO PREVENT FIRE OF SHOCK HAZARDS, DO NOT EXPOSE THIS PRODUCT TO RAIN OR MOISTURE. POWER CORD POLARIZATION CAUTION To prevent electric shock, match wide blade of plug to wide slot, fully insert. ATTENTION Pour éviter les chocs électriques, introduire la lame la plus large de la fiche dans la borne correspondante de la prise et pousser jusqu'au fond. Note to Cable TV System Installer This reminder is provided to call the cable TV installer's attention to Article 820-40 of the National Electrical Code (U. S. A. ). [. . . ] CHANNEL When playing a tape, the TV must be tuned to the same chan- 3 nel (3 or 4) as the Channel 3/4 switch on the VCP. 4 -6Note: This only applies when the RF OUT connection is used. If the VCP is connected to your TV via the Audio/Video output jacks also, choose appropriate input source at the TV, (TV Channel 3/4 or Audio/Video In. ) HOOK-UP (continued) Step 3: Connect VCP to Antenna or Cable-TV Line Your antenna/cable-TV connection will be similar to one of the illustrations below. Match yours to the one like it and make the connections shown. Disconnect the antenna or cable-TV line from the TV. The indicator lights to indicate that the power is on. EJECT Ejects a cassette from the video cassette compartment. If pressed while the VCP is turned off, the power will turn on, the cassette will be ejected, then the power will turn off automatically. STOP Stops playback, fast forward, reverse, rewind, or speed search. TRK (Tracking) Control Adjusts the tracking until video noise is lessened or eliminated. REW (Rewind) Indicator Indicates the VCP is rewinding. CST. IN (Cassette In) Indicator Indicates a cassette is in the VCP. DEW Indicator Indicates excessive moisture condensation is in the unit. Keep power on at room temperature until indicator turns off. The VCP will not operate if the DEW indicator is on. -9- 7 8 PLAY/A. TRK (Auto Tracking) Indicator Indicates tape is playing and tracking automatically. FF (Fast Forward) Indicator Indicates tape is fast forwarding. (Auto) REPEAT Indicator Indicates automatic repeat is active. Tape will automatically rewind when it reaches the end, then begin to play again. STILL Press during tape playback to pause the tape and "freeze" the picture. If left in the Still mode for five minutes, the VCP will automatically go into Stop mode to protect the tape and the VCP from possible damage. (continued on next page) OPERATION 9 (continued) picture portion of the tape is played at high speed (the sound is muted). [. . . ] Caution: Do not use dry head cleaning systems. They may seriously damage both the video cassette player an cassette. Cabinet Cleaning Clean the outside surfaces of the VCP with a soft, lint-free cloth as required. -13- NOTE -14- Your Zenith Limited Warranty VIDEO CASSETTE RECORDER OR PLAYER Welcome into the Zenith family!We believe that you will be pleased with your new Zenith Entertainment Machine. [. . . ]